參數資料
型號： ACPM-7812-BLK
元件分類： 放大器
英文描述： 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
封裝： 6 X 6 MM, 1.80 MM HEIGHT, SMT, 6 PIN
文件頁數： 11/24頁
文件大?。?/td> 193K
代理商： ACPM-7812-BLK
19
ACPM-7812 Demoboard
Operation Instructions
1) Module Description
The ACPM-7812 is a fully matched
Power Amplifier. The sample
device is provided on a demon-
stration PC Board with SMA
connectors for RF inputs and
outputs, and a DC connector for
all bias and control I/O’s.
2) Circuit Operation
The design of the power module
(PAM) provide bias control via
Vref (Vcntl) to achieve optimal
RF performance and power
control. The control pin is
labeled Vref (Vcntl). Please refer
to Figure 3 for the block diagram
of this PAM.
Typical Operation Conditions
(Vdd = 3.4V)
Parameter
ACPM-7812
Frequency Range
824 – 849 MHz
Output Power
28.5 dBm
Vcntl (Vref)
2.5 V
3) Maximum Ratings
Vdd
5.0V
Drain Current
1.5A
Vref (Vcntl)
3V
RF input
10 dBm
Temperature
-30 to 80
°C
Please Note: Avoid Electrostatic Discharge
on all I/O’s.
4) Heat Sinking
The demonstration PC Board
provides an adequate heat sink.
Maximum device dissipation
should be kept below 2.5 Watts.
5) Testing
- Signal Source
The CDMA modulated signal for
the test is generated using an
Agilent ESG-D4000A (or ESG-
D3000A) Digital Signal Generator
with the following settings:
CDMA Setup : Reverse
Spreading: On
Bits/Symbol: 1
Data: PN15
Modulation: OQPSK
Chip Rate: 1.2288 Mcps
High Crest: On
Filter: Std
Phase Polarity: Invert
- ACPR Measurement
The ACPR (and channel power) is
measured using an Agilent 4406
VSA with corresponding ACPR
offsets for IS-98c and JSTD-8.
Averaging of 10 is used for ACPR
measurements.
- DC Connection
A DC connector is provided to
allow ease of connection to the
I/O’s. Wires can be soldered to
the connector pins, or the
connector can be removed and I/
O’s contacted via clip leads or
direct soldered connections. The
wiring of I/O’s are listed in
Figure 1 through 3 and Pin
configuration table. The Vdd
sense connections are provided
to allow the use of remote-
sensing power supplies for
compensation for PCB traces and
cable resistance.
- Device Operation
1) Connect RF Input and Output
for the band under test.
2) Terminate all unused RF
ports into 50 Ohms.
3) Connect Vdd1 and Vdd2
supplies (including remote
sensing labeled Vdd1 S and
Vdd2 S on the board). Nomi-
nal voltage is 3.4V.
4) Apply RF input power accord-
ing to the values listed in
“Operation Data” in Data
Packet.
5) Connect Vref (Vcntl) supply
and set reference voltage to
the voltage shown in the data
packet. Note that the Vref
(Vcntl) pin is on the back side
of the demonstration board.
Please limit Vref (Vcntl) to not
exceed the corresponding
listed “DC Biasing Condition”
in the Data Packet. Note that
increasing Vref (Vcntl) over
the corresponding listed “DC
Biasing Condition” can result
in power decrease and
current can exceed the rated
limit.
Power Module Block Diagram
Input
Vdd1
Power
Input
Match
On Chip
Inter-stage
Match
Passive
Output
Match
Vdd2
Output
Vcntl (Vref)
相關PDF資料
PDF描述
ACPM-7813-BLK 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
ACPM-7833 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
ACPM-7881-TR1 1920 MHz - 1980 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
ACPM-7886-BLK 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
ACPM-7886-TR1 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
相關代理商/技術參數
參數描述
ACPM-7812-TR1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Amplifier. Other
ACPM-7813 制造商:Avago Technologies 功能描述:824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER
ACPM-7813-BLK 功能描述:射頻放大器 CDMA Amp 824-849MHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel
ACPM-7813-TR1 功能描述:射頻放大器 CDMA Amp 824-849MHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel
ACPM-7821 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*