- 您現在的位置：買賣IC網 > PDF目錄42383 > 935269148518 (NXP SEMICONDUCTORS) 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 PDF資料下載
參數資料
| 型號： | 935269148518 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
| 封裝： | 3.90 MM, PLASTIC, MS-012, SOT-96, SO-8 |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 178K |
| 代理商： | 935269148518 |
Philips Semiconductors
Product data
NE56605-42
System reset with built-in watchdog timer
2001 Aug 22
9
TECHNICAL DESCRIPTION
General discussion
The NE56605-42 combines a watchdog timer and an undervoltage
reset function in a single SO8 surface mount package. This provides
a space-saving solution for maintaining proper operation of typical
5.0 volt microprocessor-based logic systems. Either function, or
both, can force the microprocessor into a reset.
While the watchdog monitors the microprocessor operation, the
undervoltage reset monitors the supply voltage to the
microprocessor. If the microprocessor clock signal ceases or
becomes erratic, the NE56605-42 outputs a reset signal to the
microprocessor. If the microprocessor supply voltage sags to
4.2 volts or less, the NE56605-42 outputs a reset signal for the
duration of the supply voltage deficiency. The undervoltage reset
signal allows the microprocessor to shut down in an orderly manner
to avoid system corruption. In addition to a single reset output, the
NE56605-42 has complementary RESET and RESET outputs for
system use. The undervoltage detection threshold incorporates
hysteresis to prevent generating erratic resets.
The watchdog timer requires a pulse input. Normally this signal
comes from the system microprocessor’s clock. For operation, an
external capacitor (CT) must be connected from Pin 1 to ground.
Normally a 0.1
F capacitor is used for CT. The CT capacitor and a
fixed internal resistance establish the required minimum frequency
of watchdog input signal for the device to not output a reset signal.
In the absence of a watchdog input pulse, the CT capacitor charges
to the 0.2 volt threshold of the internal comparator, causing a reset
signal to be output. If microprocessor clock signals are received
within the required interval, no watchdog reset signal will be output.
Grounding the watchdog control pin (WDC, Pin 6) disables the
watchdog function. Removing the ground from Pin 6, allowing it to
float, enables the watchdog function. Enabling or disabling the
watchdog function has no effect on the undervoltage detection
function.
Although the temperature coefficient of detection threshold is
specified over a temperature of –20
°C to +70 °C, the device will
support operation in excess of this temperature range. See the
supporting curves for performance over the full temperature range of
–30
°C to +85 °C. Some degradation in performance will be
experienced at the temperature extremes and the system designer
should take this into account.
SL01293
8
4
3
S Q
R
7
5
SQ
R
SQ
R
2
RESET
1CT
6
GND
WDC
PULSE
GENERATOR
R
47 k
12
A
0.1 V
1.2
A
1.2
A
R
8.2 k
0.2 V
R
54 k
R
26 k
C
VCC
CP
Figure 17. Functional diagram.
相關PDF資料 |
PDF描述 |
|---|---|
| 935269503115 | 0.3 A SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO5 |
| 935269500115 | 0.3 A SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO5 |
| 935269499115 | 0.3 A SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO5 |
| 935269502115 | 0.3 A SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO5 |
| 935269497115 | 0.3 A SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 935269304128 | 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP |
| 935269544557 | 制造商:NXP Semiconductors 功能描述:SUB ONLY TDA9587-2US1-V1.3 |
| 935269987557 | 制造商:NXP Semiconductors 功能描述:SUB ONLY TDA9587-1US1-V1.8 SUBBED TO 935269987557 |
| 935270713557 | 制造商:NXP Semiconductors 功能描述:SUB ONLY IC CHP |
| 935270792551 | 制造商:NXP Semiconductors 功能描述:IC BUFF DVR TRI-ST 16BIT 56VFBGA |
發布緊急采購，3分鐘左右您將得到回復。