- 您現在的位置：買賣IC網 > PDF目錄364509 > 83F5958 IC-1.25A SWITCHING REGULATOR PDF資料下載
參數資料
| 型號： | 83F5958 |
| 英文描述： | IC-1.25A SWITCHING REGULATOR |
| 中文描述： | 集成電路1.25A的開關穩壓器 |
| 文件頁數： | 9/16頁 |
| 文件大?。?/td> | 129K |
| 代理商： | 83F5958 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
1997
4-21
MIC2172/3172
Applications Information
Using the MIC3172 Enable Control (New Designs)
Micrel
4
By using the MIC3172, U1 and Q1 shown in figure 5 can be
eliminated, reducing the total components count.
Synchronizing the MIC2172
Using several unsynchronized switching regulators in the
same circuit will cause beat frequencies to appear on the
inputs and outputs. These beat frequencies can be very low
making them difficult to filter.
Micrel’s MIC2172 can be synchronized to a single master
frequency avoiding the possibility of undesirable beat fre-
quencies in multiple regulator circuits. The master frequency
can be an external oscillator or a designated master MIC2172.
The master frequency should be 1.05 to 1.20 times the
slave’s 100kHz nominal frequency to guarantee synchroni-
zation.
4
5
Additional
Slaves
Master
10k
U3
MIC2172
V
SW
SYNC
4
5
Slave
U2
MIC2172
V
SW
SYNC
U1
4
5
Slave
MIC2172
V
SW
SYNC
Figure 6. Master/Slave Synchronization
Figure 6 shows a typical application where several MIC2172s
operate from the same supply voltage. U1’s oscillator fre-
quency is increased above U2’s and U3’s by connecting a
resistor from SYNC to ground. U2-SYNC and U3-SYNC are
capacitively coupled to the master’s output (V
SW
). The
slaves lock to the negative (falling edge) of U1’s output
waveform.
Additional
Slaves
U2
4
5
Slave
U1
MIC2172
V
SW
SYNC
4
5
Slave
MIC2172
V
SW
SYNC
External
Signal
Figure 7. External Synchronization
Care must be exercised to insure that the master MIC2172 is
always operating in continuous mode.
For new designs requiring enable/shutdown control, connect
EN to a TTL or CMOS control signal (figure 3). The very low
driver current requirement ensures compatibility regardless
of the driver or gate used.
MIC3172
EN
Enable
Shutdown
U1
Logic
Gate
4
Figure 3. MIC3172 TTL Enable/Shutdown
Using the MIC3172 in LT1172 Applications
The MIC3172 can be used in most original LT1172 applica-
tions by adapting the MIC3172’s enable/shutdown feature to
the existing LT1172 circuit.
Unlike the LT1172 which can be shutdown by reducing the
voltage on pin 2 (V
C
) below 0.15V, the MIC3172 has a
dedicated enable/shutdown pin. To replace the LT1172 with
the MIC3172, determine if the LT1172’s shutdown feature is
used.
Circuits without Shutdown
If the shutdown feature is not being used, connect EN to V
IN
to continuously enable the MIC3172 or use an MIC2172 with
SYNC open (figure 4).
MIC2172
V
IN
V
IN
SYNC
4
MIC3172
V
IN
V
IN
EN
4
N/C
Figure 4. MIC2172/3172 Always Enabled
Circuits with Shutdown
If shutdown was used in the original LT1172 application,
connect EN to a logic gate that produces a TTL logic-level
output signal that matches the shutdown signal. The MIC3172
will be enabled by a logic-high input and shutdown with a
logic-low input (figure 5). The actual components performing
the functions of U1 and Q1 may vary according to the original
application.
MIC3172
COMP
C1
R1
EN
Existing
Q1
VN2222
or equiv.
U1
Existing
Logic
Gate
add
connection
4
Enable
Shutdown
Figure 5. Adapting to the LT1172 Socket
相關PDF資料 |
PDF描述 |
|---|---|
| 83F6073 | IC-SM-8-BIT LATCH DRIVER |
| 83F6089 | IC-SM-OP AMP |
| 83F6095 | IC-LED DISPLAY DRIVER |
| 83F6096 | IC-LED DISPLAY DRIVER |
| 83F6097 | IC-LED DISPLAY DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 83F5K11 | 功能描述:線繞電阻器 - 透孔 3watt 5.11K 1% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy |
| 83F5K11E | 功能描述:線繞電阻器 - 透孔 3watt 5.11K 1% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy |
| 83F5K62 | 功能描述:線繞電阻器 - 透孔 3watt 5.62K 1% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy |
| 83F5K62E | 功能描述:線繞電阻器 - 透孔 3watt 5.62K 1% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy |
| 83F5R11 | 功能描述:線繞電阻器 - 透孔 3watt 5.11ohm 1% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy |
發布緊急采購，3分鐘左右您將得到回復。