- 您現在的位置：買賣IC網 > PDF目錄382783 > μPD705101 (NEC Corp.) 32 Bit Microprocessor(32 位微處理器) PDF資料下載
參數資料
| 型號： | μPD705101 |
| 廠商： | NEC Corp. |
| 英文描述： | 32 Bit Microprocessor(32 位微處理器) |
| 中文描述： | 32位微處理器（32位微處理器） |
| 文件頁數： | 8/72頁 |
| 文件大小： | 301K |
| 代理商： | ΜPD705101 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
μ
PD705101
8
2. INTERNAL UNITS
(1) Bus control unit (BCU)
Controls the address bus, data bus, and control bus pins. The major functions of BCU are as follows:
(a) Bus arbitration
Arbitrates the bus mastership among bus masters (CPU, DRAMC, DMAC, and external bus masters). The
bus mastership can be changed after completion of the bus cycle under execution, and in an idle state.
(b) Wait control
Controls eight areas in the 16M-byte space corresponding to RAS and seven chip select signals (CS1 through
CS7). Generates chip select signals, controls wait states, and selects the type of bus cycle.
(c) DMA controller
Generates RAS and four CAS signals, and controls access to DRAM. The hyper page mode of DRAM is
supported and DRAM can be accessed in two types of cycle: normal access (off-page) and hyper page (on-
page).
(d) ROM controller
Accessing ROM with page access function is supported. The bus cycle immediately before and addresses
are compared, and wait states are controlled in the normal access (off-page) and page access (on-page)
modes. A page width of 8 bytes to 16 bytes can be supported.
(2) Interrupt controller (ICU)
Services maskable interrupt requests (INTP00 through INTP03, and INTP10 through INTP13) from internal
peripheral hardware and external sources. The priorities of these interrupt requests can be specified in units of
four groups, and edge-triggered or level-triggered interrupts can be nested.
(3) DMA controller (DMAC)
Transfers data between memory and I/O in the place of the CPU. The transfer type is 2-cycle transfer. Two transfer
modes, single transfer and demand transfer, are available.
(4) Serial interface (UART/CSI/BRG)
One asynchronous serial interface (UART) channel and one clocked serial interface (CSI) channel is provided.
As the serial clock source, the output of the baud rate generator (BRG) and the bus clock can be selected.
(5) Real-time pulse unit (RPU)
Provides timer/counter functions. The on-chip 16-bit time/event counter and 16-bit interval timer can be used
to calculate pulse intervals and frequencies, and to output programmable pulses.
(6) Clock generator (CG)
A frequency three times higher than that of an oscillator connected to the X1 and X2 pins is supplied as the
operating clock of the CPU. In addition, a bus clock (with the same cycle as the input clock) is also supplied as
the operating clock of the peripheral units. An external clock can be also input instead of connecting an oscillator.
(7) Port (PIO)
Provides port functions. Three I/O ports are available. The pins of these ports can be used as port pins or serial
control pins.
相關PDF資料 |
PDF描述 |
|---|---|
| μPD705102GM-143-8ED | 32 Bit RISC Microcontrollers(32 位RISC 微控制器) |
| μPD705102 | 32 Bit Single Chip Microcontrollers(32 位單片微控制器) |
| μPD70F3003A | 16/32 Bit RISC Microcontrollers(16/32位單片微控制器) |
| μPD703005A | 16/32 Bit Single Chip Microcontrollers(16/32位單片微控制器) |
| μPD703025A | 16/32 Bit Single Chip Microcontrollers(16/32位單片微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PD7087 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:InGaAs PIN PHOTO DIODES |
| PD7088 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:InGaAs PIN PHOTO DIODES |
| PD708C7 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:InGaAs PIN PHOTO DIODES |
| PD708C8 | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:InGaAs PIN PHOTO DIODES |
| PD70CNT12M5MH | 制造商:Carlo Gavazzi 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。