參數資料
型號： Z0538001VSC
廠商： ZILOG INC
元件分類： 總線控制器
英文描述： SMALL COMPUTER SYSTEM INTERFACE (SCSI)
中文描述： SCSI BUS CONTROLLER, PQCC44
封裝： PLASTIC, LCC-44
文件頁數： 14/37頁
文件大?。?/td> 226K
代理商： Z0538001VSC
14
Z5380 SCSI
PS97SCC0100
Z
ILOG
FUNCTIONAL DESCRIPTION
(Continued)
Figure 25. Current SCSI Bus Status Register
Reset Conditions
Three possible reset situations exist with the Z5380, as
follows:
Hardware Chip Reset
When the signal /RST is active for at least 200 ns, the Z5380
device is re-initialized and all internal logic and control
registers are cleared. This is a chip reset only and does not
create a SCSI Bus-Reset condition.
SCSI Bus Reset (/RST) Received
When a SCSI /RST signal is received, an IRQ interrupt is
generated and a chip reset is performed. All internal logic
and registers are cleared, except for the IRQ interrupt latch
and the Assert /RST bit (bit 7) in the Initiator Command
Register. (Note: The /RST signal may be sampled by
Figure 24. Bus and Status Register
reading the Current SCSI Bus Status Register; however,
this signal is not latched and may not be present when this
port is read).
SCSI Bus Reset (/RST) Issued
If the CPU sets the Assert /RST bit (bit 7) in the Initiator
Command Register, the /RST signal goes active on the
SCSI Bus and an internal reset is performed. Again, all
internal logic and registers are cleared except for the IRQ
interrupt latch and the Assert /RST bit (bit 7) in the Initiator
Command Register. The /RST signal will continue to be
active until the Assert /RST bit is reset or until a hardware
reset occurs.
Data Transfers
Data is transferred between SCSI Bus devices in one of
four modes (Reference Figures 26-41):
1.
Programmed I/O
2.
Normal DMA
3.
Block Mode DMA
4.
Pseudo DMA
The following sections describe these modes in detail
(
Note:
For all data transfer operations, /DACK and /CS
should never be active simultaneously).
Programmed I/O Transfers
Programmed I/O is the most primitive form of data transfer.
The /REQ and /ACK handshake signals are individually
monitored and asserted by reading and writing the appro-
priate register bits. This type of transfer is normally used
when transferring small blocks of data such as command
blocks or message and status bytes. An Initiator send
operation would begin by setting the C//D, I//O, and /MSG
bits in the Target Command Register to the correct state so
that a phase match exists. In addition to the phase match
condition, it is necessary for the Assert Data Bus bit
(Initiator Command Register, bit 0) to be True and the
received I/O signal to be False for the Z5380 to send data.
For each transfer, the data is loaded into the Output Data
Register. The CPU then waits for the /REQ bit (Current SCSI
Bus Status Register, bit 5) to become active. Once /REQ
goes active, the Phase Match bit (Bus and Status Register,
bit 3) is checked and the Assert /ACK bit (Initiator Com-
mand Register, bit 4) is set. The /REQ bit is sampled until
it becomes False and the CPU resets the Assert /ACK bit
to complete the transfer.
Normal DMA Mode
DMA transfers are normally used for large block transfers.
The SCSI chip outputs a DMA request (DRQ) whenever it
is ready for a byte transfer. External DMA logic uses this
D7
D0
/ACK
/ATN
Busy Error
Phase Match
Interrupt Request Active
Parity Error
DMA Request
End of DMA
0
0
0
1
X
1
0
0
D7
D0
/DBP
/SEL
I//O
C//D
/MSG
/REQ
/BSY
/RST
0
0
0
X
X
X
0
0
PS009101-0201
相關PDF資料
PDF描述
Z0538001PSC SMALL COMPUTER SYSTEM INTERFACE (SCSI)
Z0843004 NMOS/CMOS Z80 CTC COUNTER/TIMER CIRCUIT
Z0843006 NMOS/CMOS Z80 CTC COUNTER/TIMER CIRCUIT
Z08615 NMOS 8-BIT Z8 MCU Keyboard Controller(NMOS 8位 鍵盤微控制器)
Z08617 NMOS Z8 8-BIT MCU KEYBOARD CONTROLLER
相關代理商/技術參數
參數描述
Z056 制造商:EIC 制造商全稱:EIC discrete Semiconductors 功能描述:SILICON ZENER DIODES
Z056A 制造商:EIC 制造商全稱:EIC discrete Semiconductors 功能描述:SILICON ZENER DIODES
Z056B 制造商:EIC 制造商全稱:EIC discrete Semiconductors 功能描述:SILICON ZENER DIODES
Z0603C101APMST 功能描述:電磁干擾濾波珠子、扼流圈和陣列 100ohms 2500mA RoHS:否 制造商:AVX 阻抗: 最大直流電流:35 mA 最大直流電阻: 容差: 端接類型:SMD/SMT 電壓額定值:25 V 工作溫度范圍:- 25 C to + 85 C 封裝 / 箱體:0603 (1608 metric)
Z0603C101BPWZT 功能描述:電磁干擾濾波珠子、扼流圈和陣列 RoHS:否 制造商:AVX 阻抗: 最大直流電流:35 mA 最大直流電阻: 容差: 端接類型:SMD/SMT 電壓額定值:25 V 工作溫度范圍:- 25 C to + 85 C 封裝 / 箱體:0603 (1608 metric)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*