- 您現在的位置：買賣IC網 > PDF目錄9990 > XRT75L04DIVTR-F (Exar Corporation)IC LIU E3/DS3/STS-1 4CH 176TQFP PDF資料下載
參數資料
| 型號： | XRT75L04DIVTR-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 27/98頁 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 4CH 176TQFP |
| 標準包裝： | 1,000 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 4/4 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 176-LQFP |
| 供應商設備封裝： | 176-TQFP（24x24） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁
á
XRT75L04D
REV. 1.0.1
FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
29
Case 1:
MTIP_1 connected to TTIP_1
MRING_1 connected to TRING_1
TxMON_1 (bit) = 0
As shown in the figure 18, connect MTIP_1 to TTIP_1 and MRING_1 to TRING_1 via the 270
resistors.
When no transitions on the line are detected for 128 ± 32 TxClk_1 periods, the DMO_1 pin will toggle “High”.
The DMO_1 and the DMOIS_1 bits also will be set in the control register. When the transitions are detected,
the DMO_1 pin will toggle back to normal state. The DMO_1 bit also will be cleared. However, the DMOIS_1 bit
will remain set until read. If the DMOIE_1 bit has been set, an interrupt will be generated.
Case 2:
MTIP_1 connected to TTIP_1
MRING_1 connected to TRING_1
TxMON_1 (bit) = 1
This has the same effect as in Case 1. It is redundant to use the MTIP_1/MRING_1 pins in this case.
Case 3:
MTIP_1 not connected to TTIP_1
MRING_1 not connected to TRING_1
TxMON_1 (bit) = 1
When no transitions on the TTIP_1/TRING_1 are detected for 128 ± 32 TxClk_1 periods, the DMO_1 pin will
toggle “High”. The DMO_1 and the DMOIS_1 bits also will be set in the control register. When the transitions
are detected, the DMO_1 pin will toggle back to normal state. The DMO_1 bit also will be cleared. However, the
DMOIS_1 bit will remain set until read. If the DMOIE_1 bit has been set, an interrupt will be generated. Please
note that the MTIP_1/MRING_1 pins cannot be used to monitor any other adjacent channels.
Case 4:
MTIP_m not connected to TTIP_m +n where m = 0,1...3 and n = 0,1...3
MRING_m not connected to TRING_m +n where m = 0,1...3 and n = 0,1...3
TxMON_n (bit) = 0
In this case, with external connection, any of the MTIP/MRING can be connected to any of the adjacent
channel to be monitored.
Please note that if TxMON_n bit is set, then monitoring will be done for that channel n. By toggling the
TxMON_n bit from 0 to 1, the monitoring can be switched between self-monitoring to monitoring any adajcent
channels.
NOTE: The Drive Monitor Circuit is only for diagnostic purpose and does not have to be used to operate the transmitter.
4.5
Transmitter Section On/Off:
The transmitter section of each channel can either be turned on or off. To turn on the transmitter, set the input
pin TxON_n to “High” (in Hardware Mode) or write a “1” to the TxON_n control bits (in Host Mode) with
TxON_n pins tied “High”.
When the transmitter is turned off, TTIP_n and TRing_n are tri-stated.
NOTES:
1.
This feature provides support for Redundancy.
2.
If the XRT75L04D is configured in Host mode, to permit a system designed for redundancy to quickly shut-off the
defective line card and turn on the back-up line card, writing a “1” to the TxON_n control bits transfers the control
to TxON_n pins.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B6K-IV-F2 | CONVERTER MOD DC/DC 40V 150W |
| VI-B6K-IV-F1 | CONVERTER MOD DC/DC 40V 150W |
| VI-B6J-IV-F3 | CONVERTER MOD DC/DC 36V 150W |
| IDT72815LB15PFI | IC FIFO SYNC DUAL 512X18 128TQFP |
| MS27472T12B35PA | CONN RCPT 22POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75L04ES | 功能描述:時鐘合成器/抖動清除器 4CH T3/E3/STS1 LIU+JA 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L04IV | 功能描述:外圍驅動器與原件 - PCI 4CH E3/DS3/STS1 JITTER ATTENUATOR RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75L04IV-F | 功能描述:外圍驅動器與原件 - PCI 4-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75L04IVTR | 功能描述:時鐘合成器/抖動清除器 4CH E3/DS3/STS1 JITTER ATTENUATOR RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L04IVTR-F | 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。