參數資料
型號: XRT6164AID
廠商: EXAR CORP
元件分類: 數字傳輸電路
英文描述: Digital Line Interface Transceiver
中文描述: DATACOM, PCM TRANSCEIVER, PDSO16
封裝: 0.300 INCH, SOIC-16
文件頁數: 6/10頁
文件大小: 113K
代理商: XRT6164AID
XRT6164A
6
Rev. 3.0.0
SYSTEM DESCRIPTION
The XRT6164A is a general purpose line
interface chip that con
tains the receive and
transmit circuitry necessary to convert TTL logic levels
to a CMOS signal both to and from a twisted pair cable.
Receiver
The XRT6164A receiver section converts a balanced
CMOS signal that has been attenuated and distorted
by up to 10dB of twisted pair cable to active-low TTL-
compatible logic levels.
The cable is transformer coupled to the receiver differ-
ential inputs (RX+IP, RX-IP) which are biased through
the input transformer secondary winding by a voltage
generated on-chip (I/P BIAS). The CMOS receive signal
is applied to a peak detector, and to a pair of data
comparators. The peak detector output voltage
charges an external capacitor connected to PEAK
CAP. This voltage generates a data comparator bias
level that is approximately 50% of the peak input pulse
amplitude.
Thus, data slicing is automatically accomplished at the
optimum level over the full cable loss range. TTL-
compatible output stages buffer the receiver digital
outputs (S+R, S-R) and provide active low signals
corresponding to received positive and negative input
pulses.
Loss of input signal is detected by a comparator that
monitors input signal level. An active-low TTL-compat-
ible logic level (RX ALARM) indicates signal loss.
Comparator hysteresis prevents chatter on this output.
Ping-pong operation is made possible by the time
compression multiplex control input (TCM CON). A
logic 0 applied to this pin during transmission stores
the peak detector output voltage by disconnecting the
peak detector storage capacitor charge and discharge
paths.
Since the receive data comparator bias voltage is
stored during transmit mode, it is immediately available
when receive mode resumes.
Transmitter
The XRT6164A transmitter section contains two
matched open collector output drivers that are capable
of driving the line transformer directly with a current up
to 40mA. The transmitter output drivers include diode
clamps to ensure non-saturating operation. Transmit-
ter digital inputs, which are active-low, are TTL-compat-
ible. External resistors are used between the transmit-
ter outputs and the output transformer primary to set
the output pulse amplitude.
APPLICATION INFORMATION
Figure 2
shows a general line driver application circuit
using the XRT6164A. This device converts CMOS
transmit and receive signals in the 64Kbps to
1.544Mbps range to active-low TTL-compatible logic
levels. CMOS signals that have been attenuated and
distorted by twisted pair cable are transformer-coupled
to the line side of the XRT6164A as shown on the left
side of
Figure 2
. Suggested transformers for both the
input and output applications are the Pulse types PE-
65535 or TTI-7147 for 64Kbps use and the PE-65835 for
1.544Mbps applications.
The right side of
Figure 2
shows the TTL-compatible
digital inputs and outputs. Please refer to the pin
description section of this data sheet for detailed
information about each signal.
相關PDF資料
PDF描述
XRT6164AIP Digital Line Interface Transceiver
XRT6164 Digital Line Interface Transceiver
XRT6164CD Digital Line Interface Transceiver
XRT6164CP Digital Line Interface Transceiver
XRT71D03 3-Channel E3/DS3/STS-1 Jitter Attenuator,STS-1 to DS3 Desynchronizer(達到E3/DS3/STS-1振蕩要求的3通道振蕩衰減器)
相關代理商/技術參數
參數描述
XR-T6164AID 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCM Transceiver
XRT6164AID-F 功能描述:外圍驅動器與原件 - PCI codirectionalIntrfc RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT6164AIDTR-F 功能描述:外圍驅動器與原件 - PCI codirectionalIntrfc RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT6164AIP 制造商:EXAR 制造商全稱:EXAR 功能描述:Digital Line Interface Transceiver
XR-T6164AIP 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCM Transceiver