參數資料
型號: XE8805AMI028LF
廠商: Semtech
文件頁數: 133/156頁
文件大?。?/td> 0K
描述: IC DAS 16BIT FLASH 8K MTP 64LQFP
標準包裝: 160
系列: XE880x
應用: 感測機
核心處理器: Coolrisc816?
程序存儲器類型: 閃存(22 kB)
控制器系列: XE8000
RAM 容量: 512 x 8
接口: UART,USRT
輸入/輸出數: 24
電源電壓: 2.4 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 64-LQFP
包裝: 托盤
供應商設備封裝: 64-LQFP(10x10)
產品目錄頁面: 585 (CN2011-ZH PDF)
配用: XE8000MP-ND - PROG BOARD AND PROSTART2 CARD
Semtech 2006
www.semtech.com
14-5
XE8805/05A
The word length (7 or 8 data bits) can be chosen with UartWL. A parity bit is added during transmission or checked
during reception if UartPE is set. The parity mode (odd or even) can be chosen with UartPM.
Setting the bits UartXRx and UartXTx inverts the Rx respectively Tx signals.
The bit UartEcho is used to send the received data automatically back. The transmission function becomes then:
Tx = Rx XOR UartXTx.
14.6.2
Transmission
In order to send data, the transmitter has to be enabled by setting the bit UartEnTx. Data to be sent has to be
written to the register RegUartTx. The bit UartTxFull in RegUartTxSta then goes to 1, indicating to the transmitter
that a new word is available. As soon as the transmitter has finished sending the previous word, it then loads the
contents of the register RegUartTx to an internal shift register and clears the UartTxFull bit. An interrupt is
generated on Irq_uart_Tx at the falling edge of the UartTxFull bit. The bit UartTxBusy in RegUartTxSta shows
that the transmitter is busy transmitting a word.
A timing diagram is shown in Figure 14-1. Data are first sent LSB.
New data should be written to the register RegUartTx only while UartTxFull is 0, otherwise data will be lost.
Asynchronous Transmission
write to RegUartTx
RegUartTx
word 1
reguarttx_shift
word 1
shift clock
Tx
start
b0
b1
b6/7
parity
stop
UartTxBusy
UartTxFull
Irq_uart_Tx
Asynchronous Transmission (back to back)
word 1
word 2
write to RegUartTx
RegUartTx
word 1
word 2
reguarttx_shift
word 1
word 2
shift clock
Tx
start
b0
b6/7
stop
start
UartTxBusy
UartTxFull
Irq_uart_Tx
Figure 14-1. Uart transmission timing diagram.
14.6.3
Reception
On detection of the start bit, the UartRxBusy bit is set. On detection of the stop bit, the received data are
transferred from the internal shift register to the register RegUartRx. At the same time, the UartRxFull bit is set
Not
Recommended
for
New
Designs
相關PDF資料
PDF描述
XE8807AMI026TLF IC MCU LOW PWR MTP FLASH 32-TQFP
XIO2200AGGW IC PCI-EXPRESS/BUS BRIDGE 176BGA
XIO2200AZGW IC PCI-EXPRESS/BUS BRIDGE 176BGA
XPC823ZT81B2T IC MPU POWERQUICC 81MHZ 256-PBGA
XPC8240RZU250E MCU HOST PROCESSOR 352-TBGA
相關代理商/技術參數
參數描述
XE8805AMI028TLF 制造商:Semtech Corporation 功能描述:
XE8805MI028 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Data Acquisition MCU
XE8806A 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Ultra Low-Power Low-Voltage
XE8806AMI000 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Ultra Low-Power Low-Voltage
XE8806AMI026LF 制造商:SEMTECH 制造商全稱:Semtech Corporation 功能描述:Ultra Low-Power Low-Voltage