- 您現在的位置：買賣IC網 > PDF目錄361880 > WM8192 (Wolfson Microelectronics) TVS UNIDIRECT 400W 6.5V SMA PDF資料下載
參數資料
| 型號： | WM8192 |
| 廠商： | Wolfson Microelectronics |
| 英文描述： | TVS UNIDIRECT 400W 6.5V SMA |
| 中文描述： | （8）位輸出16位獨聯體/防治荒漠化公約AFE的/數字轉換器 |
| 文件頁數： | 13/24頁 |
| 文件大小： | 619K |
| 代理商： | WM8192 |
Product Preview
WM8192
WOLFSON MICROELECTRONICS LTD
PP Rev 1.0 June 2000
13
CONTROL INTERFACE
The internal control registers are programmable via the serial digital control interface. The register
contents can be read back via the serial interface on pin OP[7]/SDO.
SERIAL INTERFACE: REGISTER WRITE
Figure 11 shows register writing in serial mode. Three pins, SCK, SDI and SEN are used. A six-bit
address (a5, 0, a3, a2, a1, a0) is clocked in through SDI, MSB first, followed by an eight-bit data
word (b7, b6, b5, b4, b3, b2, b1, b0), also MSB first. Each bit is latched on the rising edge of SCK.
When the data has been shifted into the device, a pulse is applied to SEN to transfer the data to the
appropriate internal register. Note all valid registers have address bit a4 equal to 0 in write mode.
SCK
SEN
SDI
a5
0
a3
Address
a2
a1
a0
b7
b6
b5
b4
b3
b2
b1
b0
Data Word
Figure 11 Serial Interface Register Write
SERIAL INTERFACE: REGISTER READ-BACK
Figure 12 shows register read-back in serial mode. Read-back is initiated by writing to the serial bus
as described above but with address bit a4 set to 1, followed by an 8-bit dummy data word. Writing
address (a5, 1, a3, a2, a1, a0) will cause the contents (d7, d6, d5, d4, d3, d2, d1, d0) of
corresponding register (a5, 0, a3, a2, a1, a0) to be output MSB first on pin SDO (on the falling edge
of SCK). Note that pin SDO is shared with an output pin, OP[7], therefore OEB should always be
held low when register read-back data is expected on this pin. The next word may be read in to SDI
while the previous word is still being output on SDO.
SCK
SEN
SDI
a5
1
a3 a2 a1 a0
Address
x
x
x
Data Word
x
x
x
x
x
d7 d6 d5 d4 d3 d2 d1 d0
Output Data Word
SDO/
OP[7]
OEB
Figure 12 Serial Interface Register Read-back
TIMING REQUIREMENTS
To use this device a master clock (MCLK) of up to 12MHz and a per-pixel synchronisation clock
(VSMP) of up to 6MHz are required. These clocks drive a timing control block, which produces
internal signals to control the sampling of the video signal. MCLK to VSMP ratios and maximum
sample rates for the various modes are shown in Table 4.
相關PDF資料 |
PDF描述 |
|---|---|
| WM8196 | (8+8)BIT OUTPUT 16-BIT CIS/CCD AFE/DIGITISER |
| WM8199 | 20MSPS 16-bit CCD Digitiser |
| WM8199CDR | TVS BIDIRECT 400W 60V SMA |
| WM8199CDS | TVS UNIDIRECT 400W 64V SMA |
| WM8199SCDR | 20MSPS 16-bit CCD Digitiser |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WM8195 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:14-bit 12MSPS CIS/CCD Analogue Front End/Digitiser |
| WM8195_05 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:14-bit 12MSPS CIS/CCD Analogue Front End/Digitiser |
| WM8195SCFT/RV | 功能描述:模數轉換器 - ADC 14Bit 12MSPS 3C AFE RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| WM8195SCFT/V | 功能描述:模數轉換器 - ADC 14Bit 12MSPS 3Ch AFE RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| WM8196 | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:(8 + 8) Bit Output 16-bit CIS/CCD AFE/Digitiser |
發布緊急采購，3分鐘左右您將得到回復。