參數資料
型號: W921E400
廠商: WINBOND ELECTRONICS CORP
英文描述: 4-Bit Microcontroller(4位微控制器)
中文描述: 4位微控制器(4位微控制器)
文件頁數: 34/53頁
文件大?。?/td> 394K
代理商: W921E400
W921E400A/W921C400
- 34 -
The hold released status flag1, 2, 3 (HRSTS1, 2, 3, address = 03CH, 03DH, 03EH) indicate by which
interrupt source the hold mode has been released, and is loaded by hardware. When any bit of
HRSTS1, 2, 3 is "1," the hold mode will be released and HOLD instruction in invalid. The bit
descriptions are as follows:
HRSTS1 register: (address = 03CH, read only, default data = 0H)
b3
b2
b1
b0
1: Hold was released by TM0
1: Hold was released by TM2
1: Hold was released by TM3
Reserved
HRSTS2 register: (address = 03DH, read only, default data = 0H)
b3
b2
b1
b0
1: Hold was released by the INT0 pin
1: Hold was released by serial port
1: Hold was released by comparator
Reserved
HRSTS3 register: (address = 03EH, read only, default data = 0H)
b3
b2
b1
b0
1: Hold was released by pin P4.2
Reserved
Reserved
Reserved
HRSTS1, 2 and 3 are read only registers and can be reset by the instruction CLR EVF, #I. When EVF
has been reset, the corresponding bit of HRSTSn (n = 1 to 3) is reset simultaneously.
6.12.3 Stop Mode:
The
μ
C enters the stop mode only when the STOP instruction is executed. Because the oscillator is
stopped, all functions in this chip are stopped.
The stop mode can be released by the RESET pin, INT0, P4.2, PA port or PB port. The stop
condition release flag (STPRF, address = 035H) is the stop mode release control register.
相關PDF資料
PDF描述
W925C240 Telephone Controller
W925E240 Telephone Controller
W925C625 Telephone Controller
W925E625 Telephone Controller
W9320 A-Law/u-Law CODEC
相關代理商/技術參數
參數描述
W921E400A 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER
W921E840 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER
W921E840A 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER
W921E843A 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER
W921E880 制造商:WINBOND 制造商全稱:Winbond 功能描述:4-BIT MICROCONTROLLER