- 您現在的位置：買賣IC網 > PDF目錄363898 > W78E51 (WINBOND ELECTRONICS CORP) 8-BIT MTP Monitor Microcontroller(多次可編程的8位的監視微控制器) PDF資料下載
參數資料
| 型號： | W78E51 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT MTP Monitor Microcontroller(多次可編程的8位的監視微控制器) |
| 中文描述： | 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PDIP40 |
| 封裝： | DIP-40 |
| 文件頁數： | 6/19頁 |
| 文件大?。?/td> | 283K |
| 代理商： | W78E51 |
W78E51
- 6 -
External Clock
An external clock should be connected to pin XTAL1. Pin XTAL2 should be left unconnected. The
XTAL1 input is a CMOS-type input, as required by the crystal oscillator. As a result, the external clock
signal should have an input one level of greater than 3.5 volts.
Power Management
Idle Mode
The idle mode is entered by setting the IDL bit in the PCON register. In the idle mode, the internal
clock to the processor is stopped. The peripherals and the interrupt logic continue to be clocked. The
processor will exit idle mode when either an interrupt or a reset occurs.
Power-down Mode
When the PD bit of the PCON register is set, the processor enters the power-down mode. In this
mode all of the clocks, including the oscillator are stopped. The only way to exit power-down mode is
by a reset.
Power Reduction Function
The status of the external pins during the idle and power-down modes for the W78E51 is shown in the
following tables.
ALE PSEN
1 1
1 1
0 0
0 0
P0
Data
Float
Data
Float
P1
Data
Data
Data
Data
P2
Data
Addr.
Data
Addr.
P3
Data
Data
Data
Data
Idle
internal
external
internal
external
Power
Down
Reset
The external RESET signal is sampled at S5P2. To take effect, it must be held high for at least two
machine cycles while the oscillator is running.
An internal trigger circuit in the reset line is used to deglitch the reset line when the W78E51 is used
with an external RC network. The reset logic also has a special glitch removal circuit that ignores
glitches on the reset line.
During reset, the ports are initialized to FFH, the stack pointer to 07H, PCON (with the exception of
bit 4) to 00H, and all of the other SFR registers except SBUF to 00H. SBUF is not reset.
Option Setting
The users write the program into W78E51 by the Winbond proprietorial writer. The writer programs
the data into internal 4K bytes region under programming operation and reads back to verify data.
After confirming program all right, the user can lock the data and no data can be read again.
相關PDF資料 |
PDF描述 |
|---|---|
| W78E52 | 8-BIT MTP Monitor Microcontroller(多次可編程的8位的監視微控制器) |
| W78E56B | 8-BIT Microcontroller(8位的微控制器) |
| W78E516BP-24 | 8-BIT MICROCONTROLLER |
| W78E516BP-40 | 8-BIT MICROCONTROLLER |
| W78E516 | 8-BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W78E51-16 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| W78E51-24 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| W78E51-33 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| W78E51-40 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| W78E516 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8-BIT MICROCONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。