- 您現在的位置：買賣IC網 > PDF目錄359452 > VV5430C001 (意法半導體) Monochrome Analog Output CMOS Image Sensors PDF資料下載
參數資料
| 型號： | VV5430C001 |
| 廠商： | 意法半導體 |
| 英文描述： | Monochrome Analog Output CMOS Image Sensors |
| 中文描述： | 單色模擬輸出CMOS圖像傳感器 |
| 文件頁數： | 18/33頁 |
| 文件大?。?/td> | 256K |
| 代理商： | VV5430C001 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
Exposure Control
VV5430
CD5430F-A
18/33
7.
Automatic exposure and gain control ensure operation of the VV5430 over a wide range of lighting conditions. Automatic black
level control and optional ‘Backlit’ mode further ensure consistent picture quality. The devices control exposure over a range of
99,000:1 in EIA mode and 146,000:1 in CCIR mode, and operates at illumination levels as low as 0.5 lux.
Exposure Control
Note: The System Clock can be divided by up to eight times to further increase sensitivity by extending the exposure time. This,
of course, also reduces the frame rate to non-standard values.
Automatic exposure and gain control are enabled with AEC=1 (pin 21) and AGC=1 (pin22), but can be inhibited via the serial
interface (Setup Code_1). However, If AEC is inhibited by pin 21, AGC is also inhibited and the serial interface has no control.
Inhibiting AEC or AGC via the serial interface, or by taking pin 21 or 22 low, freezes the current value(s) for these, which can then
be altered by writing to the exposure and gain control registers. (See Serial Interface for details.)
Note:
The timing of exposure and gain control messages on the serial interface is very important. External values for exposure
and gain are only applied at the start of a frame, and the serial interface must be paused until the new values are installed—no
further communications will be accepted during this time.
7.1
Automatic exposure control is achieved by varying pixel current integration time according to the average light level on the
sensor. This integration time can vary from one pixel clock period to one frame period.
Automatic Exposure Control (AEC)
Pixels above a threshold white level are counted every frame, and the number at the end of the frame defines the image as
overexposed, above average, correctly exposed, below average or underexposed. If the image is other than correctly exposed, a
new value for integration time is calculated and applied for the next frame. Corrections are either ±1/8 or ±1/64, depending upon
the degree of over or under exposure. If the exposure value is close to its limit (12% below max. or 25% above min.), then gain is
increased or decreased by one step and exposure is set to midway in its range. Exposure is then controlled as normal.
7.2
The VV5430 automatically increases the system gain of its output stage if with the current gain setting and maximum exposure
the image is too dark. Gain can be varied from x1 to x16 in times-two steps, giving five different gain settings.
Automatic Gain Control (AGC)
If the scene is too dark and the integration period has almost reached its maximum value, the gain value is incremented by one
step (times two). In the same frame period the exposure value is divided by two, halving the integration period. The exposure
controller then increases the exposure value as necessary. Similarly if the image is too bright and the integration period is short
then gain will be reduced by one step (divide by two) and the exposure value will be doubled. The exposure controller can then
adjust the exposure value as necessary to provide a correctly exposed image.
Increasing gain is limited to a programmable upper limit, for which the default value is x8. The gain upper limit is programmed by
setting bits [0..3] with header code 0101, when AGC=1. If Automatic Gain Control is inhibited (AGC=0), these registers are used
instead to select a gain setting up to x16.
相關PDF資料 |
PDF描述 |
|---|---|
| VV5430 | Integrated CMOS Image Sensor with support for ADC and external control via serial interface |
| VV6410C036 | DUAL-MODE DIGITAL CAMERA CHIPSET |
| VV6410 | XTAL MTL T/H HC49/US |
| VV6444 | Low Cost Digital Camera (LCDC) Chipset |
| VV6444C001 | Low Cost Digital Camera (LCDC) Chipset |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VV5501C001 | 功能描述:視頻 IC Monochrome Sensor RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel |
| VV5F3-30-041 | 制造商:SMC Corporation of America 功能描述:Manifold Base for VF series, base mt, 1/4 inch |
| VV5F3-30-051 | 制造商:SMC 功能描述:1/4in Five way manifold |
| VV5FS2-01T1-041-02 | 制造商:SMC Corporation of America 功能描述:Manifold, 4 station, for VFS2000 base mt series, 1/4" |
| VV5J3-S41-02-M5 | 制造商:SMC 功能描述:2station manifold for 5/2 solenoid valve |
發布緊急采購，3分鐘左右您將得到回復。