參數資料
型號: VP7615
廠商: Zarlink Semiconductor Inc.
英文描述: Colour Digital Video Camera Decoder IC
中文描述: 彩色數碼攝像機解碼器IC
文件頁數: 4/26頁
文件大?。?/td> 302K
代理商: VP7615
3
VP7615
THEORY OF OPERATION
General Overview
The VP7615 iCamHost is a fully synchronous real-time
pipeline pixel processor for converting digitized CCD
photosite samples into co-sited, colour calibrated, gamma
corrected and aperture corrected digital video in an industry-
conventional format similar to analog video decoders. The
VP7615 supports the full iVision Command Set for control
of camera head functions such as frame rate, resolution,
exposure and colour depth via the CamPort Interface.
Access to all registers and functions is provided by an I
machine.
C state
Demux and sync recovery
The incoming CCD photosite bytes come in a single nibble at
a time in a “big-endian” fashion from one of two CamPorts.
These nibbles are clocked in via a separate pixel clock signal.
The formatting signals such as start of active video, end of
active video, and start of new frame are all encoded into the
nibble stream. The output is an 8 bit byte of CCD sample for
each pixel clock, as well as separate horizontal and vertical
sync signals.
RAM control & 2H line delay FIFO RAM
Since the iCamHost assumes an interlaced scanning CCD
with a CMYG colour mosaic format, the colour content is
derived from different locations around where the output video
pixel is desired. Specifically, the first line from the CCD
contains “red-like” colour content, alternating with the
following line containing “blue-like” colour content. The third
line is real-time, and the first opportunity to output properly co-
sited luminance and chrominance as though the colour pixels
were superimposed upon themselves, all on the second line.
Pixel separator
Since the colourspace converter requires the 3 most recent
lines of CCD data, this block handles the shuffling of either the
2 red and 1 blue line, or 2 blue and 1 red line of data.
Colour matrix converter
The input to this converter is derived from the relative sums
and differences of the above 3 lines of sample data, and
processes them through a programmable 3x3 matrix
multiplier. The output is colour-separated and calibrated RGB
samples.
Gamma corrector
Since CRT monitors have a non-linear RGB intensity
response to input signal, gamma correction must be
performed in RGB space as well to prevent cross-coupling
errors between luminance and chrominance. This block is a
programmable 16 line-segment curve generator to provide
not only gamma correction, but any arbitrary contiguous curve
of positive slope, with end points at any level to adjust contrast
and range.
Colourspace converter
Since the output of the processor is to be YUV and not RGB,
a fixed-coefficient 3x3 matrix converter is used.
Chrominance sub-sampling & filtering
Spatial sub-sampling and filtering is performed since the
output sampling format must be reduced from 4:4:4 to 4:2:2
because most video systems do not require more
chrominance data for video camera input.
Output formatter
Devices taking digital video input such as capture, graphics
and compression chips usually require the YUV to be
formatted either in CCIR601 16 bit mode (YU then YV) or
CCIR656 8 bit mode(U then Y then V then Y). The output
mode (8 vs 16 bit) CCIR601 is pin-strap selectable. Additional
control register bits may be used to swap the luma and chroma
data or to swap the order of U and V data to support the video
input requirements of a variety of bus master or graphics chip
video interfaces without external glue logic. The polarity of
VSYNC, HSYNC, VACT and HACT is also programmable. An
output enable input signal may be used when “bussing” the
output with other video decoders. Other useful signals such
as field and colour flags are also provided. Timing diagrams
illustrating the function of the video outputs at different time
scales are given in figures 5 to 8.
Aperture corrector
Since both the luminance and chrominance are derived from
spatially spread pixels and the ideal output would be as though
all the pixels were superimposed upon one another, a
programmable vertical and horizontal aperture correction can
be applied to either “soften” or “sharpen” the image.
Scene-sensing luminance and chrominance metrics
There are no hard-wired closed-loop control circuits in the
processor. To achieve great flexibility in control over the
behavior of the camera head and processor system, a user-
defined region of interest is programmed which provides
statistical information about the field of video only within that
region. Peak luminance, total luminance, total red
chrominance and total blue chrominance are provided and
updated after each field.
Serial bus control
To provide read-write control over the registers within the
processor, a standard I
2
C state-machine is provided. Its
address may be offset by 3 bits to preclude address conflicts.
相關PDF資料
PDF描述
VP87A8BCGDPAS TV/Video Signal Processor
VP87A8BCGMPES TV/Video Signal Processor
VP87A9ACGDPAS TV/Video Signal Processor
VP87A9ACGMPES TV/Video Signal Processor
VPA05 Single Video Amplifier
相關代理商/技術參數
參數描述
VP7615CGFP1N 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Colour Digital Video Camera Decoder IC
VP-7710V-36001 制造商:Via Technologies, Inc 功能描述:- Bulk
VP-7710V-36121 制造商:VIA Technologies Inc 功能描述:- Bulk
VP773-10001 功能描述:高速/模塊連接器 Viper 3U Daughter Card Kit Variant A RoHS:否 制造商:Molex 系列:iPass 產品類型: 排數: 列數: 位置/觸點數量:38 安裝角:Right 節距:0.8 mm 安裝風格:Plug 端接類型:SMD/SMT 外殼材料:Thermoplastic 觸點材料:High Performance Alloy (HPA) 觸點電鍍:Gold
VP776-10001 功能描述:高速/模塊連接器 Viper 6U Daughter Card Kit Variant C RoHS:否 制造商:Molex 系列:iPass 產品類型: 排數: 列數: 位置/觸點數量:38 安裝角:Right 節距:0.8 mm 安裝風格:Plug 端接類型:SMD/SMT 外殼材料:Thermoplastic 觸點材料:High Performance Alloy (HPA) 觸點電鍍:Gold