![](http://datasheet.mmic.net.cn/160000/V59C1G01408QAUP25A_datasheet_10217432/V59C1G01408QAUP25A_27.png)
27
ProMOS TECHNOLOGIES
V59C1G01(408/808/168)QA
V59C1G01(408/808/168)QA Rev. 1.3 June 2008
Burst Mode Operation
Burst mode operation is used to provide a constant flow of data to memory locations (write cycle), or from
memory locations (read cycle). The parameters that define how the burst mode will operate are burst
sequence and burst length. The DDR2 SDRAM supports 4 bit and 8 bit burst modes only. For 8 bit burst
mode, full interleave address ordering is supported, however, sequential address ordering is nibble based for
ease of implementation. The burst length is programmable and defined by the addresses A0 ~ A2 of the
MRS. The burst type, either sequential or interleaved, is programmable and defined by the address bit 3 (A3)
of the MRS. Seamless burst read or write operations are supported. Interruption of a burst read or write oper-
ation is prohibited, when burst length = 4 is programmed. For burst interruption of a read or write burst when
burst length = 8 is used, see the “Burst Interruption “ section of this datasheet. A Burst Stop command is not
supported on DDR2 SDRAM devices.
Burst Length and Sequence
gq
Burst Length
Starting Address
(A2 A1 A0)
Sequential Addressing (decimal)
Interleave Addressing (decimal)
4
x 0 0
0, 1, 2, 3
x 0 1
1, 2, 3, 0
1, 0, 3, 2
x 1 0
2, 3, 0, 1
x 1 1
3, 0, 1, 2
3, 2, 1, 0
8
0 0 0
0, 1, 2, 3, 4, 5, 6, 7
0 0 1
1, 2, 3, 0, 5, 6, 7, 4
1, 0, 3, 2, 5, 4, 7, 6
0 1 0
2, 3, 0, 1, 6, 7, 4, 5
0 1 1
3, 0, 1, 2, 7, 4, 5, 6
3, 2, 1, 0, 7, 6, 5, 4
1 0 0
4, 5, 6, 7, 0, 1, 2, 3
1 0 1
5, 6, 7, 4, 1, 2, 3, 0
5, 4, 7, 6, 1, 0, 3, 2
1 1 0
6, 7, 4, 5, 2, 3, 0, 1
1 1 1
7, 4, 5, 6, 3, 0, 1, 2
7, 6, 5, 4, 3, 2, 1, 0
Note: 1) Page length is a function of I/O organization
128Mb X 4 organization (CA0-CA9, CA11); Page Length = 1 kByte
64Mb X 8 organization (CA0-CA9 ); Page Length = 1 kByte
32Mb X 16 organization (CA0-CA9); Page Length = 2 kByte
2) Order of burst access for sequential addressing is “nibble-based” and therefore different from SDR
or DDR components