參數資料
型號： UDA1325H
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： Universal Serial Bus USB CODEC
中文描述： SPECIALTY MICROPROCESSOR CIRCUIT, PQFP64
封裝： PLASTIC, QFP-64
文件頁數： 29/52頁
文件大?。?/td> 310K
代理商： UDA1325H
1999 May 10
29
Philips Semiconductors
Preliminary specification
Universal Serial Bus (USB) CODEC
UDA1325
A
T INITIALISATION TIME
Bit 7of the power control register (mux_ctrl_suspend) must be set to ‘1’, in order to connect the CLK_ON of the USB
processor with P3.1 of the microcontroller
Bit 6 of the power control register (mux_ctrl_int1) must be set to ‘0’, in order to connect the PSIE_MMU_INT output pin
of the USB processor with P3.3 (INT1_N) of the microcontroller
Bit 7of the I/O selection register must be set to ‘1’, in order to enable the power-on control of the 48 MHz crystal
oscillator automatically by the microcontroller.
I
N NORMAL OPERATION MODE
In normal operation working mode, a suspend can be initiated by the falling edge of the CLK_ON output signal of the
USB processor. This falling edge comes about 2 ms after the rising edge of the PSIE_MMU_SUSPEND output signal of
the USB processor. At this moment, several actions should be taken by the microcontroller:
All analog modules of the UDA1325 must be switched off; this can be done by setting bits 5 to 0 of the power control
register to ‘1’ and bit 0 of the clock shop register to ‘1’
Bit 6 of the power control register (mux_ctrl_int1) must be set to ‘1’, in order to awake from power-down by the
CLK_ON signal of the USB processor
Put all GP pins in the high or low state (depending of how they are used in the UDA1325 application)
Put the microcontroller in Power-down mode. This can be done via the PCON register of the microcontroller. This
results in an automatically switching off the 48 MHz crystal oscillator and with that all internal clocks (if they are
enabled).
On the rising edge of the CLK_ON output signal, the 48 MHz crystal oscillator will be switched on automatically and with
that all internal clocks (if they are enabled). At the same time, a counter starts counting for 2048 clock cycles (170
μ
s).
This time is necessary for stabilising the 48 MHz clock of the 48 MHz crystal oscillator.
When the counter reaches its end value (after 2048 cycles), a rising edge will be detected on the P3.3 (INT1_N) of the
microcontroller. At this moment, following actions should be taken by the microcontroller:
The Power-down mode of the microcontroller must be switched off
Re-initialise all GP pins
All analog modules of the UDA1325 must be switched on; this can be done by setting bits 5 to 0 of the power control
register to ‘0’ and bit 0 of the clock shop register to ‘0’
Bit 6 of the power control register (mux_ctrl_int1) must be set to ‘0’, in order to connect the PSIE_MMU_INT output pin
of the USB processor again with P3.3 (INT1_N) of the microcontroller.
The UDA1325 is now back in its normal operation mode and can be put back in power reduction mode by the falling edge
of the CLK_ON signal of the USB processor.
相關PDF資料
PDF描述
UDA1325PS Universal Serial Bus USB CODEC
UDA1326PS USB AUDIO-CODEC(通用串行總線音頻編解碼器)
UDA1331H Universal Serial Bus USB Audio Playback Peripheral APP
UDA1334BT Low power audio DAC
UDA1334TS Low power audio DAC
相關代理商/技術參數
參數描述
UDA1325PS 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Serial Bus USB CODEC
UDA1328 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multi-channel filter DAC
UDA1328T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multi-channel filter DAC
UDA1330A 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-cost stereo filter DAC
UDA1330ATS 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-cost stereo filter DAC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*