- 您現在的位置：買賣IC網 > PDF目錄379479 > UCC3976TRPW (Texas Instruments, Inc.) Low consumption voltage and current controller for battery chargers and adaptors PDF資料下載
參數資料
| 型號： | UCC3976TRPW |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Low consumption voltage and current controller for battery chargers and adaptors |
| 中文描述： | 鎮流器/背光控制器/驅動器| TSSOP封裝| 8引腳|塑料 |
| 文件頁數： | 12/28頁 |
| 文件大小： | 433K |
| 代理商： | UCC3976TRPW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
SLUS499A
–
NOVEMBER 2001
–
REVISED JANUARY 2002
12
www.ti.com
APPLICATION INFORMATION
lamp characteristics
A cold cathode fluorescent lamp has non-linear V-I characteristics as shown in Figure 10. The lamp
’
s intensity
(lumens) is roughly proportional to lamp current where lamp voltage remains somewhat constant over the
operating range. Lamp voltage is dependant on the diameter and length of the lamp used in the application. This
results in increased impedance when the lamp is dimmed. The impedance of the lamp will influence the gain
of the piezoelectric transformer (see Figure 9) and thus the operating frequency of the system.
start
Figure 9
60
65
70
75
80
50
0
150
100
200
300
250
ROUT = 500 k
ROUT = 250 k
ROUT = 100 k
ROUT = 750 k
f
–
Frequency
–
kHz
V
–
–
PIEZOELECTRIC GAIN
vs
FREQUENCY
strike
B
A
C
operate
Figure 10
550
500
650
600
700
800
750
500
0
1500
1000
2000
3000
2500
0
1
2
3
4
5
6
I
–
V
–
–
CCFL CURRENT
vs
LAMP VOLTAGE AND IMPEDANCE
ILAMP
–
Lamp Current
–
mA
LAMP
VOLTAGE
LAMP
IMPEDANCE
variable frequency control system
A simplified block diagram of a PZT based backlight converter is shown in Figure 11. The PZT is driven by a
resonant power stage whose amplitude is proportional to input voltage. The PZT then provides the voltage gain
necessary to drive the lamp. A control loop is formed around the error amplifier that compares average lamp
current to a reference signal (REF) allowing the intensity of the lamp to be regulated. The resulting control
voltage V
C
drives a VCO that determines the operating frequency of the resonant power stage.
The frequency range of the VCO must include the strike and operating frequencies of the PZT with some
tolerance included for component variation. Minimizing the programmable range improves the control response
of the feedback loop. For example, a frequency range of 67 kHz to 77 kHz might be used for the PZT in Figure 9.
The gain of the PZT must guarantee sufficient lamp voltage at minimum input voltage to ensure that the control
loop will always operate on the right side of resonance.
相關PDF資料 |
PDF描述 |
|---|---|
| UCC3977TRPW | BALLAST/BACKLIGHT CONTROLLER/DRIVER|TSSOP|8PIN|PLASTIC |
| UCC35705DGKTR | HIGH - SPEED VOLTAGE MODE PULSE MODE WIDTH MODULATOR |
| UCC35706DTR | HIGH - SPEED VOLTAGE MODE PULSE MODE WIDTH MODULATOR |
| UCC35706DGKTR | Aluminum Electrolytic Radial Lead High Ripple Capacitor; Capacitance: 330uF; Voltage: 400V; Case Size: 25x50 mm; Packaging: Bulk |
| UCC35705EVM | UCC35705 Evaluation Module(UCC35705評估模塊) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UCC3977PW | 功能描述:LCD 驅動器 Multi-Topology Piezoelectric RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| UCC3977PWG4 | 功能描述:LCD 驅動器 Multi-Topology Piezoelectric RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube |
| UCC3977PWR | 制造商:Texas Instruments 功能描述: |
| UCC40V680UF | 制造商:United Chemi-Con 功能描述:AL040X768 85C 13X31 |
| UCC500-30GM-IU-V1 B540 | 制造商:PEPPERL+FUCHS 功能描述:Sensor, Ultrasonic, Chem Resistant, 094792 |
發布緊急采購，3分鐘左右您將得到回復。