- 您現在的位置：買賣IC網 > PDF目錄365922 > TSP2100DBVR Analog IC PDF資料下載
參數資料
| 型號： | TSP2100DBVR |
| 英文描述： | Analog IC |
| 中文描述： | 模擬IC |
| 文件頁數： | 4/17頁 |
| 文件大小： | 351K |
| 代理商： | TSP2100DBVR |
TPS2100, TPS2101
V
AUX
POWER-DISTRIBUTION SWITCHES
SLVS197D – JUNE 1999 – REVISED JUNE 2000
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
enable
The logic enable will turn on the IN2-OUT power switch when a logic high is present on EN (TPS2100) or logic
low is present on EN (TPS2101). A logic low input on EN (TPS2100) or logic high on EN (TPS2101) restores
bias to the drive and control circuits and turns on the IN1-OUT power switch. The enable input is compatible
with both TTL and CMOS logic levels.
the V
AUX
application for CardBus controllers
The PC Card specification requires the support of V
AUX
to the CardBus controller as well as to the PC Card
sockets. Both are 3.3-V requirements; however the CardBus controller’s current demand from the V
AUX
supply
is limited to 10
μ
A, whereas the PC Card may consume as much as 200 mA. In either implementation, if support
of a wake-up event is required, the controller and the socket will transition from the 3.3-V V
CC
rail to the 3.3-V
V
AUX
rail when the equipment moves into a low power mode such as D3. The transition from V
CC
to V
AUX
needs
to be seamless in order to maintain all memory and register information in the system. If V
AUX
is not supported,
the system will lose all register information when it transitions to the D3 state.
absolute maximum ratings over operating free-air temperature (unless otherwise noted)
Input voltage range, V
I(IN1)
(see Note1)
Input voltage range, V
I(IN2)
(see Note1)
Input voltage range, V
I
at EN or EN
Output voltage range, V
O
(see Note 1)
Continuous output current, I
O(IN1
)
Continuous output current, I
O(IN2)
Continuous total power dissipation
Operating virtual junction temperature range, T
J
Storage temperature range, T
stg
Lead temperature soldering 1,6 mm (1/16 inch) from case for 10 seconds
Electrostatic discharge (ESD) protection: Human body model
–0.3 V to 5 V
–0.3 V to 5 V
–0.3 V to 5 V
–0.3 V to 5 V
700 mA
70 mA
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
See dissipation rating table
–40
°
C to 85
°
C
–65
°
C to 150
°
C
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Charged device model (CDM)
. . . . . . . . . . . . . . . . . . . . . . . . .
260
°
C
2 kV
200 V
750 V
Machine model
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: All voltages are with respect to GND.
DISSIPATION RATING TABLE
PACKAGE
TA < 25
°
C
POWER RATING
DERATING FACTOR
ABOVE TA = 25
°
C
3.1 mW/
°
C
5.7 mW/
°
C
TA = 70
°
C
POWER RATING
TA = 85
°
C
POWER RATING
DBV
309 mW
170 mW
123 mW
D
568 mW
313 mW
227 mW
recommended operating conditions
MIN
MAX
UNIT
Input voltage, VI(INx)
Input voltage, VI at EN and EN
Continuous output current, IO(IN1)
Continuous output current, IO(IN2)
Operating virtual junction temperature, TJ
The device can deliver up to 220 mA at IO(IN2). However, operation at the higher current levels will result in greater voltage drop across the device,
and greater voltage droop when switching between IN1 and IN2.
2.7
4
V
0
4
V
500
10
mA
mA
°
C
–40
85
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料 |
PDF描述 |
|---|---|
| TSP2100DBVT | Analog IC |
| TPS2201IDB | PCMCIA Switching Circuit |
| TPS2201IDBR | PCMCIA Switching Circuit |
| TPS2201IDFR | PCMCIA Switching Circuit |
| TPS2202A | 1A Dual-Slot PC Card Power Switch w/ Serial Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSP2100DBVT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| TSP212 | 制造商:Star Micronics 功能描述: |
| TSP212/VIS | 制造商:Star Micronics 功能描述: |
| TSP220A | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:AXIAL LEAD BI-DIRECTIONAL THYRISTOR SURGE PROTECTOR DEVICE |
| TSP220B | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:AXIAL LEAD BI-DIRECTIONAL THYRISTOR SURGE PROTECTOR DEVICE |
發布緊急采購，3分鐘左右您將得到回復。