- 您現在的位置：買賣IC網 > PDF目錄272329 > TS80C58X2XXX-VIA (ATMEL CORP) 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PDIP40 PDF資料下載
參數資料
| 型號： | TS80C58X2XXX-VIA |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PDIP40 |
| 封裝： | PLASTIC, DIP-40 |
| 文件頁數： | 50/83頁 |
| 文件大?。?/td> | 8336K |
| 代理商： | TS80C58X2XXX-VIA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁
49
32117D–AVR-01/12
AT32UC3C
6.2
Startup Considerations
This chapter summarizes the boot sequence of the AT32UC3C. The behavior after power-up is
controlled by the Power Manager. For specific details, refer to the Power Manager chapter.
6.2.1
Starting of clocks
At power-up, the BOD33 and the BOD18 are enabled. The device will be held in a reset state by
the power-up circuitry, until the VDDIN_33 (resp. VDDCORE) has reached the reset threshold of
the BOD33 (resp BOD18). Refer to the Electrical Characteristics for the BOD thresholds. Once
the power has stabilized, the device will use the System RC Oscillator (RCSYS, 115KHz typical
frequency) as clock source. The BOD18 and BOD33 are kept enabled or are disabled according
to the fuse settings (See the Fuse Setting section in the Flash Controller chapter).
On system start-up, the PLLs are disabled. All clocks to all modules are running. No clocks have
a divided frequency, all parts of the system receive a clock with the same frequency as the inter-
nal RC Oscillator.
6.2.2
Fetching of initial instructions
After reset has been released, the AVR32UC CPU starts fetching instructions from the reset
address, which is 0x8000_0000. This address points to the first address in the internal Flash.
The internal Flash uses VDDIO voltage during read and write operations. It is recommended to
use the BOD33 to monitor this voltage and make sure the VDDIO is above the minimum level
(3.0V).
The code read from the internal Flash is free to configure the system to use for example the
PLLs, to divide the frequency of the clock routed to some of the peripherals, and to gate the
clocks to unused peripherals.
相關PDF資料 |
PDF描述 |
|---|---|
| TSC80C51CXXX-36CW | 8-BIT, MROM, 36 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51TXXX-25IW | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51TXXX-36IXD | 8-BIT, MROM, 36 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51TXXX-L16CW | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, UUC40 |
| TSC80C51XXX-44CWD | 8-BIT, MROM, 44 MHz, MICROCONTROLLER, UUC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS80C58X2XXX-VIB | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit CMOS Microcontroller 16/32 Kbytes ROM/OTP |
| TS80C58X2XXX-VIC | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit CMOS Microcontroller 16/32 Kbytes ROM/OTP |
| TS80C58X2XXX-VIE | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit CMOS Microcontroller 16/32 Kbytes ROM/OTP |
| TS80C58X2YYY-LCAD | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MICROCONTROLLER|8-BIT|8051 CPU|CMOS|DIP|40PIN|PLASTIC |
| TS80C58X2YYY-LCBB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MICROCONTROLLER|8-BIT|8051 CPU|CMOS|LDCC|44PIN|PLASTIC |
發布緊急采購，3分鐘左右您將得到回復。