參數資料
型號: TPS62208DBV
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 0.67 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO5
封裝: PLASTIC, SOT-23, 5 PIN
文件頁數: 6/22頁
文件大小: 461K
代理商: TPS62208DBV
www.ti.com
DVout + Vout
1– Vout
Vin
L
f
1
8
Cout
f )
ESR
LAYOUT CONSIDERATIONS
VI
GND
EN
SW
FB
C1
4.7
F
L1
10
H
C2
10
F
TPS62200
VI
2.5 V 6 V
VO
1.8 V / 300 mA
R1
R2
Cff
SLVS417E – MARCH 2002 – REVISED MAY 2006
At nominal load current the device operates in PWM mode and the overall output voltage ripple is the sum of the
voltage spike caused by the output capacitor ESR plus the voltage ripple caused by charging and discharging
the output capacitor:
where the highest output voltage ripple occurs at the highest input voltage Vin.
At light load currents, the device operates in power save mode, and the output voltage ripple is independent of
the output capacitor value. The output voltage ripple is set by the internal comparator thresholds. The typical
output voltage ripple is 1% of the output voltage Vo.
Table 2. Recommended Capacitors
CAPACITOR VALUE
CASE SIZE
COMPONENT SUPPLIER
COMMENTS
4.7 F
0805
Taiyo Yuden JMK212BY475MG
Ceramic
10 F
0805
Taiyo Yuden JMK212BJ106MG
Ceramic
TDK C12012X5ROJ106K
Ceramic
10 F
1206
Taiyo Yuden JMK316BJ106KL
Ceramic
TDK C3216X5ROJ106M
22 F
1210
Taiyo Yuden JMK325BJ226MM
Ceramic
For all switching power supplies, the layout is an important step in the design, especially at high peak currents
and switching frequencies. If the layout is not carefully done, the regulator shows stability problems as well as
EMI problems.
Therefore use wide and short traces for the main current paths, as indicated in bold in Figure 17. The input
capacitor, as well as the inductor and output capacitor, should be placed as close as possible to the IC pins
The feedback resistor network must be routed away from the inductor and switch node to minimize noise and
magnetic interference. To further minimize noise from coupling into the feedback network and feedback pin, the
ground plane or ground traces must be used for shielding. This becomes very important especially at high
switching frequencies of 1 MHz.
Figure 17. Layout Diagram
14
相關PDF資料
PDF描述
TPS40055PWP SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS3824-30DBVRG4 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO5
TPS2300IPWG4 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20
TC151A2013EOA723 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
TC151A6022EOA713 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
TPS62208DBVR 功能描述:直流/直流開關調節器 1.875V Out Hi-Eff Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62208DBVRG4 功能描述:直流/直流開關調節器 1.875V Out Hi-Eff Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62208DBVT 功能描述:直流/直流開關調節器 1.875V Out Hi-Eff Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62208DBVTG4 功能描述:直流/直流開關調節器 1.875V Out Hi-Eff Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62220DDCR 功能描述:直流/直流開關調節器 Adj 400mA Hi-Eff Step-Down Con 15uA RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5