參數資料
型號： TPS61045DRB
廠商： Texas Instruments, Inc.
英文描述： DIGITALLY ADJUSTABLE LCD BOOST CONVERTER
中文描述： 數字可調液晶Boost變換器
文件頁數： 11/20頁
文件大?。?/td> 499K
代理商： TPS61045DRB
www.ti.com
fs(max)
VI
VO
L
VI
IP
VO
IP(typ)
375 mA
VI
L
100 ns
(2)
fs(ILOAD)
2
ILOAD
VO–VI
L
VF
I
2
P
IP(typ)
375 mA
VI
L
100 ns
(3)
TPS61045
SLVS440A–JANUARY 2003–REVISED SEPTEMBER 2003
APPLICATION INFORMATION
INDUCTOR SELECTION, MAXIMUM LOAD CURRENT
Since the PFM peak current control scheme is inherently stable the inductor and capacitor value does not affect
the stability of the regulator. The selection of the inductor together with the nominal load current, input, and
output voltage of the application determines the switching frequency of the converter. Depending on the
application, inductor values between 2.2 μH up to 47 μH are recommended. The maximum inductor value is
determined by the maximum switch on-time of 6 μs (typ). The peak current limit of 375 mA (typ) must be reached
within this 6 μs for proper operation.
The inductor value determines the maximum switching frequency of the converter. Therefore, the inductor value
must be selected for the maximum switching frequency, at maximum load current of the converter and should not
be exceeded. A good inductor value to start with is 4.7 μH. The maximum switching frequency is calculated as:
with:
I
P
= peak current as described in the previous
peak current control
section.
L = selected inductor value
If the selected inductor does not exceed the maximum switching frequency of the converter, as a next step, the
switching frequency at the nominal load current is estimated as follows:
with:
I
P
= peak current as described in the previous
chapter peak current control
section
L = selected inductor value
I
(LOAD)
= nominal load current
V
F
= rectifier diode forward voltage (typically 0.3 V)
The smaller the inductor value, the higher the switching frequency of the converter but the lower the efficiency.
The maximum load current of the converter is determined at the operation point where the converter starts to
enter continuous conduction mode. The converter must always operate in discontinuous conduction mode to
maintain regulation.
Two conditions exist for determining the maximum output current of the converter. One is when the inductor
current fall time is <400 ns, and the other is when the inductor current fall time is >400 ns.
One way to calculate the maximum available load current under certain operation conditions is to estimate the
expected converter efficiency at the maximum load current. This number can be taken out of the efficiency
graphs shown in Figure 2 and Figure 3. Then the maximum load current can be estimated:
Inductor fall time:
11
相關PDF資料
PDF描述
TPS611 Insulation Displacement (IDC) Connector; No. of Contacts:14; Contact Termination:IDC; Gender:Female; Contact Plating:Nickel; Leaded Process Compatible:Yes; Peak Reflow Compatible (260 C):Yes; Pitch Spacing:0.05" RoHS Compliant: Yes
TPS614 PHOTO TRANSISTOR SILICON NPN EPITAXIAL PLANAR
TPS616 PHOTO TRANSISTOR SILICON NPN EPITAXIAL PLANAR
TPS62000YEG HIGH-EFFICIENCY STEP-DOWN LOW POWER DC-DC CONVERTER
TPS62000YEGR HIGH-EFFICIENCY STEP-DOWN LOW POWER DC-DC CONVERTER
相關代理商/技術參數
參數描述
TPS61045DRBR 功能描述:LED顯示驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube
TPS61045DRBRG4 功能描述:LED顯示驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube
TPS61045DRBT 功能描述:LED顯示驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube
TPS61045DRBTG4 功能描述:LED照明驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
TPS61045EVM-231 功能描述:電源管理IC開發工具 TPS61045-231 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*