- 您現在的位置：買賣IC網 > PDF目錄69512 > TPS55386PWPR (TEXAS INSTRUMENTS INC) 7 A DUAL SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | TPS55386PWPR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 7 A DUAL SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | PLASTIC, HTSSOP-26 |
| 文件頁數： | 5/45頁 |
| 文件大?。?/td> | 1197K |
| 代理商： | TPS55386PWPR |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁
APPLICATION INFORMATION
FUNCTIONAL DESCRIPTION
Voltage Reference
Oscillator
Input Undervoltage Lockout (UVLO) and Startup
Enable and Timed Turn On of the Outputs
www.ti.com ......................................................................................................................................................................................... SLUS818 – SEPTEMBER 2008
The TPS55383 and TPS55386 are dual output, non-synchronous converters. Each PWM channel contains an
externally-compensated error amplifier, current mode pulse width modulator (PWM), switch MOSFET, enable,
and fault protection circuitry. Common to the two channels are the internal voltage regulator, voltage reference,
clock oscillator, and output voltage sequencing functions.
NOTE:
Unless otherwise noted, the term TPS5538x applies to both the TPS55383 and
TPS55386. Also, unless otherwise noted, a label with a lowercase x appended implies
the term applies to both outputs of the two modulator channels. For example, the term
ENx implies both EN1 and EN2. Unless otherwise noted, all parametric values given
are typical. Refer to the Electrical Characteristics for minimum and maximum values.
Calculations should be performed with tolerance values taken into consideration.
The bandgap cell common to both outputs is trimmed to 800 mV.
The oscillator frequency is internally fixed at two times the SWx node switching frequency. The two outputs are
internally configured to operate on alternating switch cycles (that is, 180° out-of-phase).
When the voltage at the PVDD2 pin is less than 4.1 V, a portion of the internal bias circuitry is operational, and
all other functions are held OFF. All of the internal MOSFETs are also held OFF. When the PVDD2 voltage rises
above the UVLO turn-on threshold, the state of the enable pins determines the remainder of the internal startup
sequence. If either output is enabled (ENx pulled low), the BP regulator turns on, charging the BP capacitor with
a 20-mA current. When the BP pin is greater than 4 V, PWM is enabled and soft start begins, depending on the
SEQ mode of operation and the EN1 and EN2 settings.
Note that the internal regulator and control circuitry are powered from PVDD2. The voltage on PVDD1 may be
higher or lower than PVDD2. (See the Dual Supply Operation section.)
Each output has a dedicated (active low) enable pin. If left floating, an internal current source pulls the pin to
PVDD2. By grounding, or by pulling the ENx pin to below approximately 1.2 V with an external circuit, the
associated output is enabled and soft start is initiated.
If both enable pins are left in the high state, the device operates in a shutdown mode, where the BP regulator is
shut down and minimal functions are active. The total standby current from both PVDD pins is approximately 70
A at 12-V input supply.
An R-C connected to an ENx pin may be used to delay the turn-on of the associated output after power is
applied to PVDDx (see Figure 16). After power is applied to PVDD2, the voltage on the ENx pin slowly decays
towards ground. Once the voltage decays to approximately 1.2 V, then the output is enabled and the startup
sequence begins. If it is desired to enable the outputs of the device immediately upon the application of power to
PVDD2, then omit these two components and tie the ENx pin to GND directly.
If an R-C circuit is used to delay the turn-on of the output, the resistor value must be much less than 1.2 V / 6
A
or 200 k
. A suggested value is 51 k. This resistor value allows the ENx voltage to decay below the 1.2-V
threshold while the 6-
A bias current flows.
The capacitor value required to delay the startup time (after the application of PVDD2) is shown in Equation 1.
Copyright 2008, Texas Instruments Incorporated
13
相關PDF資料 |
PDF描述 |
|---|---|
| TPS5625PWPRG4 | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS5615PWP | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS5618PWPR | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS5618PWPG4 | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS5633PWPR | 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS55386PWPRG4 | 功能描述:直流/直流開關調節器 3A,Dual Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS560200DBVR | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.8V 1 Output 500mA SC-74A, SOT-753 制造商:texas instruments 系列:SWIFT??，D-CAP2??，Eco-Mode?? 包裝:剪切帶（CT） 零件狀態:有效 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:4.5V 電壓 - 輸入（最大值）:17V 電壓 - 輸出（最小值/固定）:0.8V 電壓 - 輸出（最大值）:6.5V 電流 - 輸出:500mA 頻率 - 開關:600kHz 同步整流器:是 工作溫度:-40°C ~ 125°C （TJ） 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商器件封裝:SOT-23-5 標準包裝:1 |
| TPS560200DBVT | 制造商:Texas Instruments 功能描述:4.5V to 17V Input, 500mA Synchronous Step Down SWIFT Converter with Advanced Eco-mode 制造商:Texas Instruments 功能描述:IC, DC-DC CONVERTOR, 650KHZ, SOT23-5 制造商:Texas Instruments 功能描述:4.5-17V Input 500mA Sync Buck Cnvtr 制造商:Texas Instruments 功能描述:4.5-18V,400mASynchSWIFT(TM)convwLLE |
| TPS560200EVM-537 | 制造商:Texas Instruments 功能描述:TPS560200EVM-537 制造商:Texas Instruments 功能描述:TPS560200EVM-537 - Boxed Product (Development Kits) 制造商:Texas Instruments 功能描述:TPS560200 EVAL MOD |
| TPS560200QDGKRQ1 | 功能描述:Buck Switching Regulator IC Positive Adjustable 0.8V 1 Output 500mA 8-TSSOP, 8-MSOP (0.118", 3.00mm Width) 制造商:texas instruments 系列:汽車級，AEC-Q100，SWIFT?，Eco-Mode? 包裝:剪切帶（CT） 零件狀態:新產品 功能:降壓 輸出配置:正 拓?fù)?降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入（最小值）:4.5V 電壓 - 輸入（最大值）:17V 電壓 - 輸出（最小值/固定）:0.8V 電壓 - 輸出（最大值）:6.5V 電流 - 輸出:500mA 頻率 - 開關:600kHz 同步整流器:是 工作溫度:-40°C ~ 125°C （TJ） 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商器件封裝:8-VSSOP 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。