參數資料
型號: TPS55383PWPRG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 7 A DUAL SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO16
封裝: PLASTIC, HTSSOP-26
文件頁數: 8/45頁
文件大小: 1318K
代理商: TPS55383PWPRG4
5-V VOUT1
(2 V/div)
3.3-V VOUT2
(2 V/div)
T - Time - 1 ms/div
Soft Start
SLUS818 – SEPTEMBER 2008 ......................................................................................................................................................................................... www.ti.com
If the SEQ pin is left floating, Output 1 and Output 2 each start ratiometrically when both outputs are enabled at
the same time. Output 1 and Output 2 soft start at a rate that is determined by the respective final output
voltages and enter regulation at the same time. If the EN1 and EN2 pins are allowed to operate independently,
then the two outputs also operate independently.
Figure 20. SEQ Pin Floating
Each output has a dedicated soft-start circuit. The soft-start voltage is an internal digital reference ramp to one of
two noninverting inputs of the error amplifier. The other input is the (internal) precision 0.8-V reference. The total
ramp time for the FB voltage to charge from 0 V to 0.8 V is about 2.1 ms. During a soft-start interval, the
TPS5538x output slowly increases the voltage to the noninverting input of the error amplifier. In this way, the
output voltage ramps up slowly until the voltage on the noninverting input to the error amplifier reaches the
internal 0.8-V reference voltage. At that time, the voltage at the noninverting input to the error amplifier remains
at the reference voltage.
During the soft-start interval, pulse-by-pulse current limiting is in effect. If an overcurrent pulse is detected, six
PWM pulses are skipped to allow the inductor current to decay before another PWM pulse is applied. (See the
Output Overload Protection section.) There is no pulse skipping if a current limit pulse is not detected.
DESIGN HINT
If the rate of rise of the input voltage (PVDDx) is such that the input voltage is too low
to support the desired regulation voltage by the time soft-start has completed, then
the output UV circuit may trip and cause a hiccup in the output voltage. In this case,
use a timed delay startup from the ENx pin to delay the startup of the output until the
PVDDx voltage has the capability of supporting the desired regulation voltage. See
information.
16
Copyright 2008, Texas Instruments Incorporated
Product Folder Link(s): TPS55383 TPS55386
相關PDF資料
PDF描述
TPS5602IDBR 3 A DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO30
TPS5602IDBTRG4 3 A DUAL SWITCHING CONTROLLER, 202.4 kHz SWITCHING FREQ-MAX, PDSO30
TPS5602IDBTR 3 A DUAL SWITCHING CONTROLLER, 202.4 kHz SWITCHING FREQ-MAX, PDSO30
TPS561000PWP 1.4 A SWITCHING CONTROLLER, PDSO28
TPS56100PWPR 1.4 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS55386EVM-363 功能描述:電源管理IC開發工具 TPS55386EVM-363 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS55386PWP 功能描述:直流/直流開關調節器 3A Dual Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS55386PWPG4 功能描述:直流/直流開關調節器 3A,Dual Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS55386PWPR 功能描述:直流/直流開關調節器 3A Dual Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS55386PWPRG4 功能描述:直流/直流開關調節器 3A,Dual Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5