參數資料
型號: TPS54880PWPR
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
封裝: GREEN, PLASTIC, HTSSOP-28
文件頁數: 3/22頁
文件大小: 668K
代理商: TPS54880PWPR
TPS54880
SLVS450A OCTOBER 2002 REVISED APRIL 2005
www.ti.com
11
LAYOUT CONSIDERATIONS FOR THERMAL
PERFORMANCE
For operation at full rated load current, the analog ground
plane must provide an adequate heat dissipating area. A
3-inch by 3-inch plane of 1 ounce copper is recommended,
though not mandatory, depending on ambient temperature
and airflow. Most applications have larger areas of internal
ground plane available, and the PowerPAD must be
connected to the largest area available. Additional areas
on the top or bottom layers also help dissipate heat, and
any area available must be used when 8 A or greater
operation is desired. Connection from the exposed area of
the PowerPAD to the analog ground plane layer must be
made using 0.013 inch diameter vias to avoid solder
wicking through the vias. Eight vias must be in the
PowerPAD area with four additional vias located under the
device package. The size of the vias under the package,
but not in the exposed thermal pad area, can be increased
to 0.018. Additional vias beyond the twelve recommended
that enhance thermal performance must be included in
areas not under the device package.
Connect Pin 1 to Analog Ground Plane
in This Area for Optimum Performance
Minimum Recommended Top
Side Analog Ground Area
0.3478
0.0150
0.06
0.0256
0.1700
0.1340
0.0630
0.0400
0.0180
4 PL
0.2090
0.0130
8 PL
Minimum Recommended Exposed
Copper Area for Powerpad. 5mil
Stencils May Require 10 Percent
Larger Area
0.0650
0.0500
0.0650
0.0339
0.0500
Minimum Recommended Thermal Vias: 8 x 0.013 Diameter Inside
Powerpad Area 4 x 0.018 Diameter Under Device as Shown.
Additional 0.018 Diameter Vias May Be Used if Top Side Analog Ground
Area Is Extended.
0.3820
Figure 10. Recommended Land Pattern for 28-Pin PWP PowerPAD
相關PDF資料
PDF描述
TPS54973PWP 16 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54974PWP 16 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54974PWPG4 16 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54974PWPR 16 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS54980PWP 16 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS54880PWPRG4 功能描述:直流/直流開關調節器 5V Inp 8A Sync Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS548A20EVM-737 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1
TPS548A20RVET 功能描述:Buck Switching Regulator IC Positive Adjustable 0.6V 1 Output 15A 28-VFQFN Exposed Pad 制造商:texas instruments 系列:SWIFT?,D-CAP3?,Eco-Mode? 包裝:剪切帶(CT) 零件狀態:有效 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入(最小值):1.5V 電壓 - 輸入(最大值):20V 電壓 - 輸出(最小值/固定):0.6V 電壓 - 輸出(最大值):5.5V 電流 - 輸出:15A 頻率 - 開關:可選 同步整流器:無 工作溫度:-40°C ~ 125°C(TA) 安裝類型:表面貼裝 封裝/外殼:28-VFQFN 裸露焊盤 供應商器件封裝:28-VQFN(4.5x3.5) 標準包裝:1
TPS548B22EVM-847 功能描述:EVAL BOARD FOR TPS548B22 制造商:texas instruments 系列:SWIFT?,D-CAP3?,Eco-Mode? 零件狀態:在售 主要用途:DC/DC,步降 輸出和類型:1,非隔離 電壓 - 輸出:1V 電流 - 輸出:25A 電壓 - 輸入:5 V ~ 14 V 穩壓器拓撲:降壓 頻率 - 開關:650kHz 板類型:完全填充 所含物品:板 使用的 IC/零件:TPS548B22 標準包裝:1
TPS548B22RVFT 功能描述:IC REG BUCK ADJ 25A 40LQFN 制造商:texas instruments 系列:SWIFT?,D-CAP3?,Eco-Mode? 包裝:剪切帶(CT) 零件狀態:在售 功能:降壓 輸出配置:正 拓撲:降壓 輸出類型:可調式 輸出數:1 電壓 - 輸入(最小值):1.5V 電壓 - 輸入(最大值):18V 電壓 - 輸出(最小值/固定):0.6V 電壓 - 輸出(最大值):5.5V 電流 - 輸出:25A 頻率 - 開關:可選 同步整流器:是 工作溫度:-40°C ~ 125°C(TA) 安裝類型:表面貼裝 封裝/外殼:40-LFQFN 裸露焊盤 供應商器件封裝:40-LQFN-CLIP(7x5) 標準包裝:1