- 您現在的位置：買賣IC網 > PDF目錄385947 > TPS54880EVM (Texas Instruments, Inc.) 8-Amp SWIFT Regulator Evaulation Module(8A SWIFT穩壓器TPS54880的評估模塊) PDF資料下載
參數資料
| 型號： | TPS54880EVM |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 8-Amp SWIFT Regulator Evaulation Module(8A SWIFT穩壓器TPS54880的評估模塊) |
| 中文描述： | 8安培的SWIFT穩壓Evaulation模塊（8A條SWIFT的穩壓器TPS54880的評估模塊） |
| 文件頁數： | 20/44頁 |
| 文件大?。?/td> | 1180K |
| 代理商： | TPS54880EVM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
Input/Output Connections
2-2
2.1
Input/Output Connections
The TPS54x80EVM-228 has the following input/output connections: 5-V
input, 5-V input return, 3.3-V output, 3.3-V output return, 1.8-V output and
1.8-V output return. A diagram showing the connection points is shown in
Figure 2-1. A power supply capable of supplying 15 A should be connected
to J1 through a pair of 16 AWG wires. The 3.3-V and 1.8-V loads should be
connected respectively to J2 and J3 through pairs of 16 AWG wires. The
maximum load current may be reduced from 8 A to 6 A, if the 6-A version of
the TPS54x80EVM-228 with TPS54680/TPS54610 regulators is used. Wire
lengths should be minimized to reduce losses in the wires. Test points TP10
and TP11 provide a place to easily connect an oscilloscope voltage probe to
monitor the output voltages, while TP4 provides a test point for monitoring the
input voltage. The TPS54x80 device is intended to be used as a point of load
regulator typically located close to the input voltage source. When using the
TPS54x80EVM-228 with an external laboratory power supply as the source
for Vin, an additional bulk capacitor may be required, depending upon the
output impedance of the source and length of the hookup wires. The presented
test results were obtained using a 470
μ
F, 16 V additional input capacitor.
IMPORTANT NOTICE:
The two-channel TPS54x80EVM-228 EVM requires an input voltage of
4.5-V to 6-V to provide 3.3-V output from the TPS54610/TPS54810
regulators for I/O voltage. Stand-alone measurements of TPS54680
regulator operating at a 3.3-V input voltage are also provided for reference.
The TPS54680 has a rated input voltage range of 3.0 to 6.0 V, and may be
powered from a 3.3-V bus in some applications.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54980EVM-022 | 9-Amp SWIFT Regulator Evaulation Module(9A SWIFT穩壓器TPS54980的評估模塊) |
| TPS5602DBT | DUAL, FAST, HIGH EFFICIENCY CONTROLLER FOR DSP POWER |
| TPS5904(中文) | Opto-Isolated Feedback AMP(光電隔離反饋放大器,包括TL431和光電隔離耦合器) |
| TPS5910(中文) | Opto-Isolated Feedback AMP(光隔離反饋放大器,包含TLV431可編程基準和光耦合器) |
| TPS5908(中文) | Opto-Isolated Feedback AMP(光隔離反饋放大器,包含TLV431可編程基準和光耦合器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54880PWP | 功能描述:直流/直流開關調節器 5V Inp 8A Sync Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54880PWPG4 | 功能描述:直流/直流開關調節器 5V Inp 8A Sync Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54880PWPR | 功能描述:直流/直流開關調節器 5V Inp 8A Sync Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54880PWPRG4 | 功能描述:直流/直流開關調節器 5V Inp 8A Sync Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS548A20EVM-737 | 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。