- 您現在的位置：買賣IC網 > PDF目錄220080 > TPS54383PWPR (TEXAS INSTRUMENTS INC) 7 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | TPS54383PWPR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 7 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | GREEN, PLASTIC, HTSSOP-14 |
| 文件頁數： | 19/58頁 |
| 文件大?。?/td> | 1773K |
| 代理商： | TPS54383PWPR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
www.ti.com
Output Overload Protection
Operating Near Maximum Duty Cycle
OUT
DIODE
IN
DIODE
V
+
d =
+
(15)
SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007
In the event of an overcurrent during soft start on either output (such as starting into an output short),
pulse-by-pulse current limiting and PWM frequency division are in effect for that output until the internal soft start
timer ends. At the end of the soft start time, a UV condition is declared and a fault is declared. During this fault
condition, both PWM outputs are disabled and the small pulldown MOSFETs (from SWx to GND) are turned ON.
This process ensures that both outputs discharge to GND in the event that overcurrent is on one output while the
other is not loaded. The converter then enters a hiccup mode timeout before attempting to restart. "Frequency
Division" means if an overcurrent pulse is detected, six clock cycles are skipped before a next PWM pulse is
initiated, effectively dividing the operating frequency by six and preventing excessive current build up in the
inductor.
In the event of an overcurrent on either output after the output reaches regulation, pulse-by-pulse current limit is
in effect for that output. In addition, an output undervoltage (UV) comparator monitors the FBx voltage (that
follows the output voltage) to declare a fault if the output drops below 85% of regulation. During this fault
condition, both PWM outputs are disabled and the small pulldown MOSFETs (from SWx to GND) are turned ON.
This design ensures that both outputs discharge to GND, in the event that overcurrent is on one output while the
other is not loaded. The converter then enters a hiccup mode timeout before attempting to restart.
The overcurrent threshold for Output 1 is set nominally at 4.5 A. The overcurrent level of Output 2 is determined
by the state of the ILIM2 pin. The ILIM setting of Output 2 is not latched in place and may be changed during
operation of the converter.
Table 2. Current Limit Threshold Adjustment for
Output 2
ILIM2 Connection
OCP Threshold for Output 2
BP
4.5 A nominal setting
(floating)
3.0 A nominal setting
GND
1.5 A nominal setting
DESIGN HINT
The OCP threshold refers to the peak current in the internal switch. Be sure to add
one-half of the peak inductor ripple current to the dc load current in determining how
close the actual operating point is to the OCP threshold
If the TPS5438x operates at maximum duty cycle, and if the input voltage is insufficient to support the output
voltage (at full load or during a load current transient), then there is a possibility that the output voltage will fall
from regulation and trip the output UV comparator. If this should occur, the TPS5438x protection circuitry will
declare a fault and enter a shut down-and-restart cycle.
DESIGN HINT
Ensure that under ALL conditions of line and load regulation, there is sufficient duty
cycle to maintain output voltage regulation.
To calculate the operating duty cycle, use Equation 15.
where
V
DIODE is the voltage drop of the rectifier diode
26
Copyright 2007, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TC7660SEOA | SWITCHED CAPACITOR REGULATOR, 45 kHz SWITCHING FREQ-MAX, PDSO8 |
| TPS3110E12DBVT | 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO6 |
| TOP248F | 7.2 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PZIP6 |
| TD075-048-15M | 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE |
| TD100-150-12M | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54383PWPRG4 | 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54386 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SWIFT Converter Product Portfolio |
| TPS54386EVM | 功能描述:電源管理IC開發工具 TPS54386 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS54386PWP | 功能描述:直流/直流開關調節器 DC/DC Controller RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54386PWP | 制造商:Texas Instruments 功能描述:DC/DC Controller |
發布緊急采購，3分鐘左右您將得到回復。