參數資料
型號: TPS54383PWPR
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 7 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14
封裝: GREEN, PLASTIC, HTSSOP-14
文件頁數: 18/58頁
文件大?。?/td> 1773K
代理商: TPS54383PWPR
www.ti.com
Inductor
Current
V
OUT
Ripple
SW Waveform
Steady State
V
IN
= 12 V
V
OUT
= 5 V
SW Waveform
V
OUT
Ripple
Inductor
Current
Skipping
V
IN
= 12 V
V
OUT
= 5 V
SW Node Ringing
SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007
Figure 32. Steady State
Figure 33. Skipping
DESIGN HINT
If additional output capacitance is required to reduce the output voltage ripple during
DCM operation, be sure to recheck Feedback Loop and Inductor-Capacitor (L-C)
A portion of the control circuitry is referenced to the SW node. To ensure jitter-free operation, it is necessary to
decrease the voltage waveform ringing at the SW node to less than 5 volts peak and of a duration of less than
30-ns. In addition to following good printed circuit board (PCB) layout practices, there are a couple of design
techniques for reducing ringing and noise.
SW Node Snubber
Voltage ringing observable at the SW node is caused by fast switching edges and parasitic inductance and
capacitance. If the ringing results in excessive voltage on the SW node, or erratic operation of the converter, an
R-C snubber may be used to dampen the ringing and ensure proper operation over the full load range.
DESIGN HINT
A series-connected R-C snubber (C = between 330 pF and 1 nF, R = 10
)
connected from SW to GND reduces the ringing on the SW node.
Bootstrap Resistor
A small resistor in series with the bootstrap capacitor reduces the turn-on time of the internal MOSFET, thereby
reducing the rising edge ringing of the SW node.
DESIGN HINT
A resistor with a value between 1
and 3 may be placed in series with the bootstrap
capacitor to reduce ringing on the SW node.
DESIGN HINT
Placeholders for these components should be placed on the initial prototype PCBs in
case they are needed.
Copyright 2007, Texas Instruments Incorporated
25
Product Folder Link(s): TPS54383 TPS54386
相關PDF資料
PDF描述
TC7660SEOA SWITCHED CAPACITOR REGULATOR, 45 kHz SWITCHING FREQ-MAX, PDSO8
TPS3110E12DBVT 1-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO6
TOP248F 7.2 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PZIP6
TD075-048-15M 1-OUTPUT 75 W DC-DC REG PWR SUPPLY MODULE
TD100-150-12M 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
TPS54383PWPRG4 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386 制造商:TI 制造商全稱:Texas Instruments 功能描述:SWIFT Converter Product Portfolio
TPS54386EVM 功能描述:電源管理IC開發工具 TPS54386 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS54386PWP 功能描述:直流/直流開關調節器 DC/DC Controller RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWP 制造商:Texas Instruments 功能描述:DC/DC Controller