- 您現在的位置：買賣IC網 > PDF目錄98283 > TPS54350MPWPREP (TEXAS INSTRUMENTS INC) 7.2 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | TPS54350MPWPREP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 7.2 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | GREEN, PLASTIC, HTSSOP-16 |
| 文件頁數： | 8/36頁 |
| 文件大?。?/td> | 1057K |
| 代理商： | TPS54350MPWPREP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
www.ti.com
APPLICATION INFORMATION
BOOT
PWRGD
RT
PH
VBIAS
LSG
VIN
UVLO
SYNC
ENA
VSENSE
VOUT
VIA to Ground Plane
VIN
GND
COMP
GND
PGND
AGND
PCB LAYOUT
TPS54350-EP
SGLS308 – OCTOBER 2005
Figure 21. TPS54350 PCB Layout
The VIN pins should be connected together on the printed circuit board (PCB) and bypassed with a low ESR
ceramic bypass capacitor. Care should be taken to minimize the loop area formed by the bypass capacitor
connections, the VIN pins, and the TPS54350 ground pins. The minimum recommended bypass capacitance is
10-F ceramic with a X5R or X7R dielectric and the optimum placement is closest to the VIN pins and the AGND
and PGND pins. See Figure 21 for an example of a board layout. The AGND and PGND pins should be tied to
the PCB ground plane at the pins of the IC. The source of the low-side MOSFET and the anode of the Schottky
diode should be connected directly to the PCB ground plane. The PH pins should be tied together and routed to
the drain of the low-side MOSFET or to the cathode of the external Schottky diode. Since the PH connection is
the switching node, the MOSFET (or diode) should be located close to the PH pins, and the area of the PCB
conductor minimized to prevent excessive capacitive coupling. The recommended conductor width from pins 14
and 15 is 0.05 inch to 0.075 inch of 1-ounce copper. The length of the copper land pattern should be no more
than 0.2 inch.
For operation at full rated load, the analog ground plane must provide adequate heat dissipating area. A 3-inch
by 3-inch plane of copper is recommended, though not mandatory, dependent on ambient temperature and
airflow. Most applications have larger areas of internal ground plane available and the PowerPAD should be
connected to the largest area available. Additional areas on the bottom or top layers also help dissipate heat,
and any area available should be used when 3 A or greater operation is desired. Connection from the exposed
area of the PowerPAD to the analog ground plane layer should be made using 0.013-inch diameter vias to avoid
solder wicking through the vias. Four vias should be in the PowerPAD area with four additional vias outside the
pad area and underneath the package. Additional vias beyond those recommended to enhance thermal
performance should be included in areas not under the device package.
16
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54372PWP | 3 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54418RTER | 6.4 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS54426PWP | 7.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO14 |
| TPS54429PWP | 0.01 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO14 |
| TPS5450MDDAREP | 11.7 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54350MPWPREPG4 | 功能描述:直流/直流開關調節器 4.5 to 20V Input,3A Step Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWP | 功能描述:直流/直流開關調節器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWP | 制造商:Texas Instruments 功能描述:IC's |
| TPS54350PWPG4 | 功能描述:直流/直流開關調節器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWPR | 功能描述:開關變換器、穩壓器與控制器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。