- 您現在的位置：買賣IC網 > PDF目錄98283 > TPS54350MPWPREP (TEXAS INSTRUMENTS INC) 7.2 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | TPS54350MPWPREP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 7.2 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | GREEN, PLASTIC, HTSSOP-16 |
| 文件頁數： | 13/36頁 |
| 文件大?。?/td> | 1057K |
| 代理商： | TPS54350MPWPREP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
www.ti.com
I
CIN +
I
OUT(MAX)
2
(11)
OUTPUT FILTER COMPONENTS
Inductor Selection
L
MIN +
V
OUT(MAX)
V
IN(MAX) *
V
OUT
V
IN(max)
K
IND
I
OUT
F
SW
(12)
I
L(RMS)
+
I2
OUT(MAX) )
1
12
V
OUT
V
IN(MAX)
* VOUT
V
IN(MAX)
L
OUT
F
SW
0.8
2
(13)
I
L(PK) +
I
OUT(MAX) )
V
OUT
V
IN(MAX) *
V
OUT
1.6
V
IN(MAX)
L
OUT
F
SW
(14)
Capacitor Selection
TPS54350-EP
SGLS308 – OCTOBER 2005
In this case the input ripple voltage would be 140 mV and the RMS ripple current would be 1.5 A. The maximum
voltage across the input capacitors would be VIN max plus delta VIN/2. The chosen bulk and bypass capacitors
are each rated for 25 V and the combined ripple current capacity is greater than 3 A, both providing ample
margin. It is important that the maximum ratings for voltage and current are not exceeded under any
circumstance.
Two components need to be selected for the output filter, L1 and C2. Since the TPS54350 is an externally
compensated device, a wide range of filter component types and values can be supported.
To calculate the minimum value of the output inductor, use Equation 12:
KIND is a coefficient that represents the amount of inductor ripple current relative to the maximum output current.
For designs using low ESR output capacitors such as ceramics, use KIND = 0.3. When using higher ESR output
capacitors, KIND = 0.2 yields better results.
For this design example, use KIND = 0.2 and the minimum inductor value is calculated to be 8.98 H. The next
highest standard value is 10 H, which is used in this design.
For the output filter inductor it is important that the RMS current and saturation current ratings not be exceeded.
The RMS inductor current can be found from Equation 13:
and the peak inductor current can be determined with Equation 14:
For this design, the RMS inductor current is 3.01 A and the peak inductor current is 3.34 A. The chosen inductor
is a Vishay IHLP5050CE-01 10 H. It has a saturation current rating of 14 A and a RMS current rating of 7 A,
easily meeting these requirements. A lesser rated inductor could be used, however this device was chosen
because of its low profile component height. In general, inductor values for use with the TPS54350 are in the
range of 6.8 H to 47mH.
The important design factors for the output capacitor are dc voltage rating, ripple current rating, and equivalent
series resistance (ESR). The dc voltage and ripple current ratings cannot be exceeded. The ESR is important
because along with the inductor current it determines the amount of output ripple voltage. The actual value of the
output capacitor is not critical, but some practical limits do exist. Consider the relationship between the desired
closed loop crossover frequency of the design and LC corner frequency of the output filter. In general, it is
desirable to keep the closed loop crossover frequency at less than 1/5 of the switching frequency. With high
switching frequencies such as the 500-kHz frequency of this design, internal circuit limitations of the TPS54350
limit the practical maximum crossover frequency to about 50 kHz. Additionally, to allow for adequate phase gain
in the compensation network, the LC corner frequency should be about one decade or so below the closed loop
crossover frequency. This limits the minimum capacitor value for the output filter to:
20
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54372PWP | 3 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20 |
| TPS54418RTER | 6.4 A SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, PQCC16 |
| TPS54426PWP | 7.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO14 |
| TPS54429PWP | 0.01 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO14 |
| TPS5450MDDAREP | 11.7 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS54350MPWPREPG4 | 功能描述:直流/直流開關調節器 4.5 to 20V Input,3A Step Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWP | 功能描述:直流/直流開關調節器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWP | 制造商:Texas Instruments 功能描述:IC's |
| TPS54350PWPG4 | 功能描述:直流/直流開關調節器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS54350PWPR | 功能描述:開關變換器、穩壓器與控制器 4.5 to 20V Inp 3A Step-Down Converter RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。