- 您現在的位置：買賣IC網 > PDF目錄365924 > TPS3613-18DGST Analog IC PDF資料下載
參數資料
| 型號： | TPS3613-18DGST |
| 英文描述： | Analog IC |
| 中文描述： | 模擬IC |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 214K |
| 代理商： | TPS3613-18DGST |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
TPS3600D20, TPS3600D33, TPS3600D50
BATTERY-BACKUP SUPERVISORS FOR LOW-POWER PROCESSORS
SLVS336 – DECEMBER 2000
8
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
50
VBAT
VDD
3.6 V
25
Equivalent
Source Impedance
50
Cable
50
CEIN
CEOUT
CL
50 pF
GND
VDD
TPS3600
CL Includes load capacitance and scope probe capacitance.
Figure 3. CE Propagation Delay Test Circuit
power-fail comparator (PFI and PFO)
An additional comparator is provided to monitor voltages other than the nominal supply voltage. The power-fail
input (PFI) will be compared with an internal voltage reference of 1.15 V. If the input voltage falls below the
power-fail threshold (V
(PFI)
) of 1.15 V typical, the power-fail output (PFO) goes low. If it goes above 1.15 V plus
about 20-mV hysteresis, the output returns to high. By connecting two external resistors, it is possible to
supervise any voltages above 1.15 V. The sum of both resistors should be about 1 M
, to minimize power
consumption and also to ensure that the current in the PFI pin can be neglected compared with the current
through the resistor network. The tolerance of the external resistors should be not more than 1% to ensure
minimal variation of sensed voltage.
If the power-fail comparator is unused, connect PFI to ground and leave PFO unconnected.
BATTON
Most often BATTON is used as a gate or base drive for an external pass transistor for high-current applications.
In addition it can be also used as a logic output to indicate the battery switchover status. BATTON is high when
V
OUT
is connected to V
BAT
.
BATTON can be directly connected to the base of a PNP transistor (see Figure 4a) or the gate of a PMOS
transistor (see Figure 4b). No current-limiting resistor is required, but a resistor connecting the base of the PNP
to BATTON can be used to limit the current drawn from V
DD
, prolonging battery life in portable equipment. If
you are using a PMOS transistor, however, it must be connected backwards from the traditional method (see
Figure 4b). This method orients the body diode from V
DD
to V
OUT
and prevents the backup battery from
discharging through the FET when its gate is high.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS3613-25DGSR | Analog IC |
| TPS3613-25DGST | Analog IC |
| TPS3613-30DGSR | Analog IC |
| TPS3613-30DGST | Analog IC |
| TPS3613-33DGSR | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS3613-25DGSR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| TPS3613-25DGST | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| TPS3613-30DGSR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| TPS3613-30DGST | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| TPS3613-33DGSR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
發布緊急采購，3分鐘左右您將得到回復。