- 您現在的位置：買賣IC網 > PDF目錄385946 > TPS2831PWP (Texas Instruments, Inc.) FAST SYNCHRONOUS-BUCK MOSFET DRIVERS WITH DEADTIME CONTROL PDF資料下載
參數資料
| 型號： | TPS2831PWP |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | FAST SYNCHRONOUS-BUCK MOSFET DRIVERS WITH DEADTIME CONTROL |
| 中文描述： | 快速同步賽珍珠MOSFET驅動器與死區控制 |
| 文件頁數： | 12/15頁 |
| 文件大?。?/td> | 198K |
| 代理商： | TPS2831PWP |
TPS2830, TPS2831
FAST SYNCHRONOUS-BUCK MOSFET DRIVERS
WITH DEADTIME CONTROL
SLVS196B – JANUARY1999 – REVISED SEPTEMBER 1999
12
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
Great care should be taken when laying out the pc board. The power-processing section is the most critical and
will generate large amounts of EMI if not properly configured. The junction of Q1, Q2, and L1 should be very
tight. The connection from Q1 drain to the positive sides of C5, C10, and C11 and the connection from Q2 source
to the negative sides of C5, C10, and C11 should be as short as possible. The negative terminals of C7 and
C12 should also be connected to Q2 source.
Next, the traces from the MOSFET driver to the power switches should be considered. The BOOTLO signal from
the junction of Q1 and Q2 carries the large gate drive current pulses and should be as heavy as the gate drive
traces. The bypass capacitor (C14) should be tied directly across V
CC
and PGND.
The next most sensitive node is the FB node on the controller (terminal 4 on the TL5001A) This node is very
sensitive to noise pick up and should be isolated from the high-current power stage and be as short as possible.
The ground around the controller and low-level circuitry should be tied to the power ground as the output. If these
three areas are properly laid out, the rest of the circuit should not have any other EMI problems and the power
supply will be relatively free of noise.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS3106(中文) | ULTRALOW SUPPLY-CURRENT/SUPPLY-VOLTAGE SUPERVISORY CIRCUITS(超低電流/電壓監控電路) |
| TPS3123J18D | Ultralow Voltage Processor Supervisory Circuits(電源電壓監視1.8V,門限電壓1.62V,極低電壓微處理監控電路) |
| TPS3305(中文) | Dual Processor Supervisors(雙處理器監控器) |
| TPS3306(中文) | Dual Processor Supervisry Circuits With Power-Fall(帶電源故障比較器的雙監控電路) |
| TPS3306 | Dual Processor Supervisry Circuits With Power-Fall(帶電源故障比較器的雙監控電路) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2831PWPG4 | 功能描述:功率驅動器IC Inv Fast Sync Buck MOSFET Driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2831PWPR | 功能描述:功率驅動器IC Inv Fast Sync Buck MOSFET Driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2831PWPRG4 | 功能描述:功率驅動器IC Inv Fast Sync Buck MOSFET Driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2832D | 功能描述:功率驅動器IC Non-inv Fast Sync Buck Driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2832D | 制造商:Texas Instruments 功能描述:IC SYNC BUCK FET DRIVER 8-SOIC 制造商:Texas Instruments 功能描述:IC, SYNC BUCK FET DRIVER 8-SOIC 制造商:Texas Instruments 功能描述:IC, SYNC BUCK FET DRIVER 8-SOIC; Device Type:MOSFET; Module Configuration:High Side, Low Side; Peak Output Current:2.4A; Supply Voltage Min:4.5V; Supply Voltage Max:15V; Driver Case Style:SOIC; No. of Pins:8; Input Delay:60ns; Output;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。