參數資料
型號: TPS2363PFBG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 電源管理
英文描述: 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48
封裝: PLASTIC, TQFP-48
文件頁數: 6/44頁
文件大?。?/td> 840K
代理商: TPS2363PFBG4
C
FILTER +
t
FLT
I
FILTER
V
FILTER
1000
C
FILTER +
t
FLT
R
FILTER
SF
Normal operating current
Charging
Bulk
Capacitors
Fault level
Current Limit Turn On
SLUS680B – JANUARY 2006 – REVISED JANUARY 2010
www.ti.com
Fault Timer
To avoid nuisance trips, the turn off time of the main power supplies and AUX in a normal over-current event is
controlled by a fault timer. The over current comparator’s response time, tFLT, is user selectable and set by
external capacitors, one for each channel. Connect the capacitor from FILTERA/B to ground. The fault timer
capacitor, CFILTERA/B, is calculated by the following equation:
Using the full range of VFILTER and IFILTER given in the Timing Parameters section, CFILTER and the associated
fault time can vary up to 60% without component tolerances. For increased accuracy of the fault timer, connect a
110-k
resistor from pin RFILTERA/B to ground. Recalculate the CFILTERA/B by the following equation:
Where RFILTER is the 110-k 1% resistor and SF is the scaling factor in the Timing Parameters section. This
technique is accurate to less than 22%, apart from component tolerances.
Competitive parts based on the published datasheet calculate to 200% without the resistor and 27% with the
resistor.
Current Limit
A current limit hot plug controller protects the system against over loads and glitches to the backplane power
rails by limiting the amount of current that a module can draw. When the module has been in current limit for the
fault time then the circuit opens. If the fault goes away before the fault time expires the module goes back to the
normal running mode. The disadvantage is the voltage on the module can drop during the current limit, and can
leave the logic on the module in a unknown state or hung state. The module may have to be reset or the power
cycled to the module to reset the logic.
Figure 3 shows the module turn on using current limit, when current limiting is used the fault timer is typically set
for a longer period than circuit breaker. It takes longer to charge up the capacitors when the current is limited.
Figure 3. Hot Plug Current Limit Turn ON
14
Copyright 2006–2010, Texas Instruments Incorporated
Product Folder Link(s): TPS2363
相關PDF資料
PDF描述
TPS2370PW 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8
TPS23753PW 0.505 A SWITCHING CONTROLLER, 273 kHz SWITCHING FREQ-MAX, PDSO14
TPS2376DDA-HG4 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8
TPS2376DDAR-H 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8
TPS2376DDA-H 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8
相關代理商/技術參數
參數描述
TPS2363PFBR 功能描述:熱插拔功率分布 PCIExpress Srvr Dual Slot Hot Plug Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2363PFBRG4 功能描述:熱插拔功率分布 PCIExpress Srvr Dual Slot Hot Plug Cntrlr RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2370D 功能描述:熱插拔功率分布 IEEE 802.3af Pwr Ifc Switch For PoE PD’s RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2370DG4 功能描述:熱插拔功率分布 IEEE 802.3af Pwr Ifc Switch For PoE PD’s RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube
TPS2370DR 功能描述:熱插拔功率分布 IEEE 802.3af Pwr Ifc Switch For PoE PD’s RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube