參數資料
型號: TPA321DGNR
元件分類: 音頻放大器
英文描述: Single Audio Amplifier
中文描述: 單音頻放大器
文件頁數: 17/22頁
文件大?。?/td> 424K
代理商: TPA321DGNR
TPA321
350-mW MONO AUDIO POWER AMPLIFIER
WITH DIFFERENTIAL INPUTS
SLOS312A – JUNE 2000 – REVISED JUNE 2000
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
input capacitor, C
I
In the typical application an input capacitor, C
I
, is required to allow the amplifier to bias the input signal to the
proper dc level for optimum operation. In this case, C
I
and R
I
form a high-pass filter with the corner frequency
determined in equation 8.
(8)
–3 dB
fc
fc
1
2 RICI
The value of C
I
is important to consider as it directly affects the bass (low frequency) performance of the circuit.
Consider the example where R
I
is 10 k
and the specification calls for a flat bass response down to 40 Hz.
Equation 8 is reconfigured as equation 9.
(9)
CI
1
2 RIfc
In this example, C
I
is 0.40
μ
F, so one would likely choose a value in the range of 0.47
μ
F to 1
μ
F. A further
consideration for this capacitor is the leakage path from the input source through the input network (R
I
, C
I
) and
the feedback resistor (R
F
) to the load. This leakage current creates a dc offset voltage at the input to the amplifier
that reduces useful headroom, especially in high gain applications. For this reason a low-leakage tantalum or
ceramic capacitor is the best choice. When polarized capacitors are used, the positive side of the capacitor
should face the amplifier input in most applications, as the dc level there is held at V
DD
/2, which is likely higher
than the source dc level. It is important to confirm the capacitor polarity in the application.
power supply decoupling, C
S
The TPA321 is a high-performance CMOS audio amplifier that requires adequate power supply decoupling to
ensure the output total harmonic distortion (THD) is as low as possible. Power supply decoupling also prevents
oscillations for long lead lengths between the amplifier and the speaker. The optimum decoupling is achieved
by using two capacitors of different types that target different types of noise on the power supply leads. For
higher frequency transients, spikes, or digital hash on the line, a good low equivalent-series-resistance (ESR)
ceramic capacitor, typically 0.1
μ
F, placed as close as possible to the device V
DD
lead, works best. For filtering
lower-frequency noise signals, a larger aluminum electrolytic capacitor of 10
μ
F or greater placed near the audio
power amplifier is recommended.
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料
PDF描述
TPA321DR Single Audio Amplifier
TPA6011A4PWPR Slide
TPA6017A2PWPR AUDIO AMPLIFIER|DUAL|CMOS|TSSOP|20PIN|PLASTIC
TPA6030A4 3-W Stereo Audio Power Amplifier with Advanced DC Volume Control
TPA6030A4PWP Slide
相關代理商/技術參數
參數描述
TPA321DGNRG4 功能描述:音頻放大器 350-mW Low-Voltage w/diff inputs RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA321DR 功能描述:音頻放大器 350-mW Low-Voltage w/diff inputs RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA321DRG4 功能描述:音頻放大器 350-mW Low-Voltage w/diff inputs RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA321EVM 功能描述:音頻 IC 開發工具 TPA321 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
TPA3221DDV 功能描述:HIGH POWER AMPLIFIER 制造商:texas instruments 系列:- 包裝:管件 零件狀態:在售 類型:D 類 電壓 - 電源:7 V ~ 32 V 安裝類型:表面貼裝 工作溫度:0°C ~ 70°C 供應商器件封裝:44-HTSSOP 封裝/外殼:44-TSSOP(0.240",6.10mm 寬)裸露焊盤 標準包裝:35