參數資料
型號: TMS320DM643GDK500
廠商: Texas Instruments, Inc.
元件分類: 數字信號處理
英文描述: Video/Imaging Fixed-Point Digital Signal Processo
中文描述: 視頻/影像定點數字信號Processo
文件頁數: 98/123頁
文件大?。?/td> 1205K
代理商: TMS320DM643GDK500
www.ti.com
t
d(IDLEXCOL)
X1/X2
or XCLKIN
XCLKOUT
HALT
HALT
Wake-up Latency
Flushing Pipeline
t
d(WAKEHALT)
(A)
(B)
(C)
(D)
Device
Status
(E)
(G)
(F)
PLL Lock-up Time
Normal
Execution
t
w(WAKE-GPIO)
t
p
GPIOn
Oscillator Start-up Time
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
Table 6-18. HALT Mode Timing Requirements
MIN
NOM
MAX
UNIT
cycles
cycles
t
w(WAKE-GPIO)
t
w(WAKE-XRS)
(1)
See
Table 6-11
for an explanation of t
oscst
.
Pulse duration, GPIO wake-up signal
Pulse duration, XRS wakeup signal
t
oscst
+ 2t
c(OSCCLK)(1)
t
oscst
+ 8t
c(OSCCLK)
Table 6-19. HALT Mode Switching Characteristics
PARAMETER
MIN
TYP
MAX
UNIT
cycles
cycles
t
d(IDLE-XCOL)
t
p
Delay time, IDLE instruction executed to XCLKOUT low
PLL lock-up time
Delay time, PLL lock to program execution resume
Wake up from flash
Flash module in sleep state
32t
c(SCO)
45t
c(SCO)
131072t
c(OSCCLK)
1125t
c(SCO)
cycles
t
d(WAKE-HALT)
35t
c(SCO)
cycles
Wake up from SARAM
A.
B.
IDLE instruction is executed to put the device into HALT mode.
The PLL block responds to the HALT signal. SYSCLKOUT is held for approximately 32 cycles before the oscillator is
turned off and the CLKIN to the core is stopped. This 32-cycle delay enables the CPU pipe and any other pending
operations to flush properly.
Clocks to the peripherals are turned off and the PLL is shut down. If a quartz crystal or ceramic resonator is used as
the clock source, the internal oscillator is shut down as well. The device is now in HALT mode and consumes
absolute minimum power.
When the GPIOn pin is driven low, the oscillator is turned on and the oscillator wake-up sequence is initiated. The
GPIO pin should be driven high only after the oscillator has stabilized. This enables the provision of a clean clock
signal during the PLL lock sequence. Since the falling edge of the GPIO pin asynchronously begins the wakeup
procedure, care should be taken to maintain a low noise environment prior to entering and during HALT mode.
When GPIOn is deactivated, it initiates the PLL lock sequence, which takes 131,072 OSCCLK (X1/X2 or X1 or
XCLKIN) cycles.
When CLKIN to the core is enabled, the device will respond to the interrupt (if enabled), after a latency. The HALT
mode is now exited.
Normal operation resumes.
C.
D.
E.
F.
G.
Figure 6-13. HALT Wake Up Using GPIOn
98
Electrical Specifications
相關PDF資料
PDF描述
TMS320C6211PYP167 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6211PQ150 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6211PQ120 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6211PQ100 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320VC5421PGE DIGITAL SIGNAL PROCESSOR
相關代理商/技術參數
參數描述
TMS320DM643GDK600 制造商:Rochester Electronics LLC 功能描述:VIDEO/IMAGING FIXED-POINT DIGITAL SIGNAL PROCESSOR - Bulk
TMS320DM643GNZ500 制造商:Texas Instruments 功能描述:DSP FIX PT 32BIT 500MHZ 4000MIPS 548FCBGA - Trays
TMS320DM643GNZ600 制造商:Rochester Electronics LLC 功能描述:VIDEO/IMAGING FIXED-POINT DIGITAL SIGNAL PROCESSOR - Bulk 制造商:Texas Instruments 功能描述:
TMS320DM6441AZWT 功能描述:數字信號處理器和控制器 - DSP, DSC DaVinci Dig Media SOC RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320DM6441BZWT 功能描述:數字信號處理器和控制器 - DSP, DSC DaVinci Dig Media Sys-on-Chip RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT