- 您現在的位置：買賣IC網 > PDF目錄69494 > TLE8242 (INFINEON TECHNOLOGIES AG) SPECIALTY ANALOG CIRCUIT, PQFP64 PDF資料下載
參數資料
| 型號： | TLE8242 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQFP64 |
| 封裝： | GREEN, PLASTIC, LQFP-64 |
| 文件頁數： | 15/77頁 |
| 文件大小： | 1580K |
| 代理商： | TLE8242 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
TLE8242
Functional Description and Electrical Characteristics
Data Sheet
22
Rev. 1.0, 2009-02-25
Figure 9
Diagnostic Block Diagram
5.3.1
On-State Diagnostics
When the OUTx pin transitions high, the fault timers are cleared to 0 and the tested timer starts. If the tested timer
expires, the Bit SB-T (in the SPI registers #4 and #5) is set to 1. If the OUTx pin transitions low, the tested timer
is cleared and then used for the off-state diagnostics.
If the analog SB fault signal (SB-FA) changes to 1, the fault filter timer starts. If the fault filter timer expires, the
digitally filtered SB fault signal (SB-FD) is set to one. If SB-FA changes to 0, SB-FD changes immediately to 0 and
the filter timer is cleared to 0.
A SB-FD=1 and SB-T=1 switches off the OUTx signal and the SB-F bit in the FAULT register will be set. The OUTx
pin remains in the off state until the fault retry PWM period counter expires.
If the SPI message #3 or #4 is read, then the SB-F bit and the SB-FT bit in this register are cleared. Also, the tested
timer is cleared to 0.
The Short to Battery (SB) detection functions in both direct PWM and constant current mode. The SG-FD and OL-
OFF-FD signals are held to 0 while the OUTx pin is high.
If the TLE8242 IC is in direct PWM mode, Open Load ON detection is disabled (OL-ON-F = 0).
If the TLE8242 IC is not in direct PWM mode and the OUTx pin is high for 64 PWM periods, then the open load
fault ON mode fault is detected, and the OL-ON-F bit in the diagnostic register is set. This bit will be cleared when
SPI message #3 or #4 is read. If the OUTx pin remains in a high state, then the open load - on fault condition is
detected again after another 64 PWM cycles.
Predivider
1:128
1:192
1:256
Tested timer
1..10
(shared)
digital filter
open load OFF
(only while OFF)
digital filter
short to ground
(only while OFF)
digital filter
short to battery
(only while ON)
Gate On Counter
1..64
fault filter timer
(1..10) (shared)
V
POS
V
OL
V
POS
V
SG
V
POS
V
SB
OL-FA
SG-FA
SB-FA
PWM mode enabled
PWM Start
clear
LOGIC
Divider Select
(SPI register)
Masterclock
OL-OFF-FD
SG-FD
SB-FD
OL-ON-F
OL-OFF-F (Open Load Off Fault)
SG-F (Short to Ground Fault)
SB-F (Short to Battery Fault)
OL-ON-F (Open Load On Fault)
OFF-T (Short to Ground and Open
Load Off Tested)
SB-T (Short to Battery Tested)
read SPI fault
register
Gate is ON
clear
相關PDF資料 |
PDF描述 |
|---|---|
| TLE8386EL | 0.09 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLI4946-2L | MAGNETIC SENSOR, PSIP3 |
| TLI4946K | MAGNETIC SENSOR, PDSO3 |
| TLV431AIDBVR | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
| TLV431ACDBVT | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 1.24 V, PDSO5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE8242-2 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8 Channel Fixed Frequency Constant Current Control With Current Profile Detection |
| TLE82452SAALLA1 | 制造商:Infineon Technologies AG 功能描述:TRANSMISSION_IC - Rail/Tube |
| TLE82452SAAUMA1 | 制造商:Infineon Technologies AG 功能描述:TRANSMISSION_IC - Tape and Reel |
| TLE8250G | 功能描述:CAN 接口集成電路 High Speed CAN Transceiver RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TLE8250GVIO | 功能描述:CAN 接口集成電路 High Speed CAN Transceiver RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。