- 您現在的位置：買賣IC網 > PDF目錄196436 > TISP83121D-S (BOURNS INC) 22 A, SILICON SURGE PROTECTOR PDF資料下載
參數資料
| 型號： | TISP83121D-S |
| 廠商： | BOURNS INC |
| 元件分類： | 浪涌電流限制器 |
| 英文描述： | 22 A, SILICON SURGE PROTECTOR |
| 封裝： | ROHS COMPLIANT, SOIC-8 |
| 文件頁數： | 4/5頁 |
| 文件大?。?/td> | 180K |
| 代理商： | TISP83121D-S |
FEBRUARY 1999 – REVISED JANUARY 2007
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
APPLICATIONS INFORMATION
TISP83121D Unidirectional P & N-Gate Protector
Multiple Line Overvoltage Protection
Figure 2 shows two TISP83121D devices protecting many lines. Line conductor positive overvoltage protection is given by the steering diode
array connected to the anode of the upper TISP83121D and the TISP83121D itself. The TISP83121D gate reference voltage is the positive
battery supply, +VBAT. The initial limiting voltage will be the sum of the voltages of the battery, the forward biased conductor diode, the gate
trigger of the TISP83121D and the forward biased reference voltage blocking diode. Typically the conductor voltage will be initially limited at
2.5 V above the +VBAT value.
Figure 2. N Line Positive and Negative Overvoltage Protection
K
A
G1
TISP83121D
G2
K
A
G1
TISP83121D
G2
0
-VE
REFERENCE
VOLTAGE
AI8XAA
+VE
REFERENCE
VOLTAGE
LINE 1
IN
LINE N
IN
R1
T1
RN
TN
SLIC 1
SLIC N
R
+V
BAT
-V
BAT
Line conductor negative overvoltage protection is given by the diode steering array connected to the cathode of the lower TISP83121D and
the TISP83121D itself. The TISP83121D gate reference voltage is the negative battery supply, -VBAT. The initial limiting voltage will be the sum
of the voltages of the battery, the forward biased conductor diode, the gate trigger of the TISP83121D and the forward biased reference
voltage blocking diode. Typically the conductor voltage will be initially limited at 2.5 V below the -VBAT value.
When a TISP83121D crowbars and grounds all conductors of the appropriate polarity, the device current will be the sum of all the SLIC output
currents. This will usually exceed the TISP83121D holding current. To switch off the TISP83121D and restore normal operation, the grounded
condition of the SLIC output must be detected and the SLIC outputs turned off.
The 150 A rating of the TISP83121D allows a large number of lines to be protected against currents caused by lightning. For example, if a
recommendation K.20 10/700 generator was connected to all lines, together with 350 V primary protection and a series conductor resistance
(R) of 25 , the maximum conductor current before the primary protection operated would be 350/25 = 14 A or 28 A per line. For a total return
current of about 150 A the number of lines would be 150/28 = 5. At this current level, 5x28 = 140 A, the generator voltage would
be140((25+25)/10+15) = 2800 V. Another limitation is long term power cross. The long term power cross capability of the TISP83121D is 3 A
peak or 2.1 A rms. If the line conductor overcurrent protection was given by a PTC thermistor which tripped at 0.2 A, the maximum number of
conductors becomes 2.1/0.2 = 10 or 5 lines.
相關PDF資料 |
PDF描述 |
|---|---|
| TJ32UEB271L | 1 ELEMENT, 267.3 uH, GENERAL PURPOSE INDUCTOR |
| TJ32UEB2R2L | 1 ELEMENT, 2.11 uH, GENERAL PURPOSE INDUCTOR |
| TJ41UEB181L | 1 ELEMENT, 178.18 uH, GENERAL PURPOSE INDUCTOR |
| TJ41UEB681L | 1 ELEMENT, 679.69 uH, GENERAL PURPOSE INDUCTOR |
| TJ42UEB102L | 1 ELEMENT, 1005.02 uH, GENERAL PURPOSE INDUCTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP9110LDM | 功能描述:SCR OVER VOLTAGE PROT RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP9110LDMR-S | 功能描述:SCR Dual Polarity SLIC RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP9110LDMS | 功能描述:SCR OverVolt Protector RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP9110MDMR-S | 制造商:Bourns Inc 功能描述: 制造商:Bourns Inc 功能描述:SURGE PROT THYRIST NEG/POS SLIC 制造商:Bourns Inc 功能描述:SCRs Dual Polarity SLIC 150/80/50A |
| TISPA79R241DR | 功能描述:硅對稱二端開關元件 RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
發布緊急采購，3分鐘左右您將得到回復。