- 您現在的位置：買賣IC網 > PDF目錄382590 > TISP8201MDR-S (BOURNS INC) COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION PDF資料下載
參數資料
| 型號： | TISP8201MDR-S |
| 廠商： | BOURNS INC |
| 元件分類： | 保護電路 |
| 英文描述： | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
| 中文描述： | TELECOM, SURGE PROTECTION CIRCUIT, PDSO8 |
| 封裝： | ROHS COMPLIANT, PLASTIC, MS-012, SO-8 |
| 文件頁數： | 6/13頁 |
| 文件大?。?/td> | 335K |
| 代理商： | TISP8201MDR-S |
MAY 1998 - REVISED FEBRUARY 2005
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
TISP8200M & TISP8201M
APPLICATIONS INFORMATION
Operation of SLICs using Positive and Negative Voltage Supply Rails
Figure 3 shows a typical powering arrangement for a multi-supply rail SLIC. VBATR is a positive supply and VBATL and VBATH are negative
supplies. VBATH is more negative than VBATL. With the positive and negative supply switches S2 and S1 in the positions shown, the line
driver amplifiers are powered between 0 V and VBATL. This mode minimizes the power consumption for short loop transmission. For long
loops, the driver voltage is increased by operating S1 to connect VBATH. To generate ringing, S2 is operated to apply VBATR, powering the
drivers from a total supply voltage of VBATR - VBATH. These conditions are shown in Figure 4.
Figure 4. Driver Supply Voltage Levels
0 V
V
BATL
SHORT LOOP
V
BATH
0 V
LONG LOOP
V
DCRING
V
SLICR
V
PKRING
/2
V
SLICH
V
BATR
AI8XAG
V
BATH
V
V
-
BATR
BATH
RINGING
V
PKRING
/2
V
PKRING
/2
V
PKRING
/2
Conventional ringing is typically unbalanced ground or battery backed. To minimize the supply voltage required, most multi-rail SLICs use
balanced ringing as shown in Figure 4. The ringing has d.c., VDCRING, and a.c., VPKRING, components. A 70 V rms a.c. ring signal has a
peak value, VPKRING, of 99 V. If the d.c. component was 20 V, then the total voltage swing needed would be 99 + 20 = 119 V. There are
internal losses in the SLIC from the positive supply, VSLICR, and the negative supply, VSLICH. The sum of these two losses generally amounts
to a total of 10 V. This makes a total supply rail value of 119 + 10 = 129 V. In practice, the voltage might be distributed as VBATR = +60 V and
VBATH = -70 V. These values are nominal and some extra voltage should be provided to cover power supply voltage tolerance.
Figure 3. SLIC
withVoltage Supply Switching
S1
LINE
DRIVERS
V
BATH
S2
0 V
V
BATR
SLIC
AI8XAF
SUPPLY
SWITCHES
LINE
V
BATL
相關PDF資料 |
PDF描述 |
|---|---|
| TISP8200MDR | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
| TISP8200MDR-S | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
| TISP8201MDR | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
| TISP820XM | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
| TISP8210MDR-S | COMPLEMENTARY BUFFERED-GATE SCRS FOR DUAL POLARITY SLIC OVERVOLTAGE PROTECTION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP8210MDR-S | 功能描述:SCR -150mA High Hold current RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP8211MDR-S | 功能描述:SCR +20mA High Hold current RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP8250D | 制造商:Bourns Inc 功能描述: |
| TISP8250DR | 制造商:Bourns Inc 功能描述: |
| TISP8250DR-S | 功能描述:SCR PROTECTOR - GATED UNIDIRECTIONAL RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。