參數資料
型號: TDA7407
廠商: STMICROELECTRONICS
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PQFP44
封裝: 10 X 10 MM, 1.40 MM HEIGHT, LQFP-44
文件頁數: 25/46頁
文件大?。?/td> 692K
代理商: TDA7407
Obsolete
Product(s)
- Obsolete
Product(s)
TDA7407
Multipath detector
5.3
Automatic threshold control mechanism
5.3.1
Automatic threshold control by the stereoblend voltage
Besides the noise controlled threshold adjustment there is an additional possibility for
influencing the trigger threshold. It is depending on the stereoblend control.
The point where the MPX signal starts to become noisy is fixed by the RF part. Therefore
also the starting point of the normal noise-controlled trigger adjustment is fixed. In some
cases the behaviour of the noiseblanker can be improved by increasing the threshold even
in a region of higher fieldstrength.
Sometimes a wrong triggering occures for the MPX signal often shows distortion in this
range which can be avoided even if using a low threshold. Because of the overlap of this
range and the range of the stereo/mono transition it can be controlled by stereoblend.
This threshold increase is programmable in 3 steps or switched off with bits D0 and D1 of
the fieldstrength control byte.
5.3.2
Over deviation detector
If the system is tuned to stations with a high deviation the noiseblanker can trigger on the
higher frequencies of the modulation. To avoid this wrong behaviour, which causes noise in
the output signal, the noiseblanker offers a deviation dependent threshold adjustment.
By rectifying the MPX signal a further signal representing the actual deviation is obtained. It
is used to increase the PEAK voltage. Offset and gain of this circuit are programmable in 3
steps with the bits D6 and D7 of the stereo decoder byte (the first step turns off the detector,
see fig. 18).
5.4
Functional description of the multipath detector
Using the internal multipath detector the audible effects of a multipath condition can be
minimized. A multipath condition is detected by rectifying the 19kHz spectrum in the
fieldstrength signal.An external capacitor is used to define the attack and decay times (see
block diagram Figure 24). the MPOUT pin is used as detector output connected to a
capacitor of about 47nF and additionally the MPIN pin is selected to be the fieldstrength
input.
Using the configuration, an external user requirement adaptation is given in Figure 24.
To keep the old value of the Multipath Detector during an AF-jump, the external capacitor
can be disconnected by the MP Hold switch. This switch can be controlled directly by the
AFS Pin.
Selecting the "internal influence" in the configuration byte, the channel separation is
automatically reduced during a multipath condition according to the voltage appearing at the
MP_OUT pin. A possible application is shown in Figure 24.
相關PDF資料
PDF描述
TDA7409D 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410NDTR 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410ND 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7411 2 CHANNEL(S), TONE CONTROL CIRCUIT, PQFP44
相關代理商/技術參數
參數描述
TDA7407_07 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Advanced car signal processor
TDA7407D 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7407DTR 功能描述:IC PROCESSOR ADV SIGNAL 44-LQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 音頻處理 系列:- 其它有關文件:STA321 View All Specifications 標準包裝:1 系列:Sound Terminal™ 類型:音頻處理器 應用:數字音頻 安裝類型:表面貼裝 封裝/外殼:64-LQFP 裸露焊盤 供應商設備封裝:64-LQFP EP(10x10) 包裝:Digi-Reel® 其它名稱:497-11050-6
TDA7407TR 功能描述:處理器 - 專門應用 Advanced car signal processor RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432
TDA7409 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CARRADIO-SIGNAL-PROCESSOR