參數資料
型號: TCM129C14
廠商: Texas Instruments, Inc.
元件分類: Codec
英文描述: Single-Chip PCM Codecs And Filters(組合編碼譯碼器/濾波器,模擬環路)
中文描述: 單芯片的PCM編解碼器和過濾器(組合編碼譯碼器/濾波器,模擬環路)
文件頁數: 17/25頁
文件大?。?/td> 556K
代理商: TCM129C14
TCM29C13, TCM29C14, TCM29C16, TCM29C17,
TCM129C13, TCM129C14, TCM129C16, TCM129C17
COMBINED SINGLE-CHIP PCM CODEC AND FILTER
SCTS011G – APRIL 1986 – REVISED JULY 1996
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
system reliability and design considerations
General TCM29C13, TCM29C14, TCM29C16, TCM29C17, TCM129C13, TCM129C14, TCM129C16, and
TCM129C17 system reliability and design considerations are described in the following paragraphs.
latch-up
Latch-up is possible in all CMOS devices. It is caused by the firing of a parasitic SCR that is present due to the
inherent nature of CMOS. When a latch-up occurs, the device draws excessive amounts of current and will
continue to draw heavy current until power is removed. Latch-up can result in permanent damage to the device
if supply current to the device is not limited.
Even though the TCM29Cxx and TCM129Cxx are heavily protected against latch-up, it is still possible to cause
latch-up under certain conditions in which excess current is forced into or out of one or more terminals. Latch-up
can occur when the positive supply voltage drops momentarily below ground, when the negative supply voltage
rises momentarily above ground, or possibly if a signal is applied to a terminal after power has been applied
but before the ground is connected. This can happen if the device is hot-inserted into a card with the power
applied, or if the device is mounted on a card that has an edge connector, and the card is hot-inserted into a
system with the power on.
To help ensure that latch-up does not occur, it is considered good design practice to connect a reverse-biased
Schottky diode (with a forward voltage drop of less than or equal to 0.4 V — 1N5711 or equivalent), between
each power supply and GND (see Figure 7). If it is possible that a TCM29Cxx- or TCM129Cxx-equipped card
that has an edge connector could be hot-inserted into a powered-up system, it is also important to ensure that
the ground edge connector traces are longer than the power and signal traces so that the card ground is always
the first to make contact.
device power-up sequence
Latch-up can also occur if a signal source is connected without the device being properly grounded. A signal
applied to one terminal could then find a ground through another signal terminal on the device. To ensure proper
operation of the device and as a safeguard against this sort of latch-up, it is recommended that the following
power-up sequence always be used:
1.
Ensure no signals are applied to the device before the power-up sequence is complete.
2.
Connect GND.
3.
Apply V
BB
(most negative voltage).
Apply V
CC
(most positive voltage).
Force a power down condition in the device.
4.
5.
6.
Connect the clocks.
7.
Release the power-down condition.
8.
Apply FSX and/or FXR synchronization pulses.
9.
Apply signal inputs.
When powering down the device, this procedure should be followed in the reverse order.
相關PDF資料
PDF描述
TCM129C16 Single-Chip PCM Codecs And Filters(組合編碼譯碼器/濾波器)
TCM320AC36DW VOICE-BAND AUDIO PROCESSORS VBAPE
TCM320AC36N VOICE-BAND AUDIO PROCESSORS VBAPE
TCM320AC36PT VOICE-BAND AUDIO PROCESSORS VBAPE
TCM320AC37DW VOICE-BAND AUDIO PROCESSORS VBAPE
相關代理商/技術參數
參數描述
TCM129C14DW 制造商:TI 制造商全稱:Texas Instruments 功能描述:COMBINED SINGLE-CHIP PCM CODEC AND FILTER
TCM129C16 制造商:TI 制造商全稱:Texas Instruments 功能描述:COMBINED SINGLE-CHIP PCM CODEC AND FILTER
TCM129C16A 制造商:TI 制造商全稱:Texas Instruments 功能描述:COMBINED SINGLE-CHIP PCM CODEC AND FILTER
TCM129C16ADW 制造商:TI 制造商全稱:Texas Instruments 功能描述:COMBINED SINGLE-CHIP PCM CODEC AND FILTER
TCM129C16AN 制造商:TI 制造商全稱:Texas Instruments 功能描述:COMBINED SINGLE-CHIP PCM CODEC AND FILTER