參數資料
型號： T89C51RD2-DDFI-L
廠商： Atmel Corp.
英文描述： IC - OPTOISOLATOR 4N28
中文描述： 0至40MHz可編程閃存8位微控制器
文件頁數： 81/170頁
文件大?。?/td> 1927K
代理商： T89C51RD2-DDFI-L
81
A/T89C51CC01
4129L–CAN–08/05
Figure 41.
CAN Bit Construction
Synchronization Segment
The first segment is used to synchronize the various bus nodes.
On transmission, at the start of this segment, the current bit level is output. If there is a
bit state change between the previous bit and the current bit, then the bus state change
is expected to occur within this segment by the receiving nodes.
Propagation Time Segment
This segment is used to compensate for signal delays across the network.
This is necessary to compensate for signal propagation delays on the bus line and
through the transceivers of the bus nodes.
Phase Segment 1
Phase Segment 1 is used to compensate for edge phase errors.
This segment may be lengthened during resynchronization.
Sample Point
The sample point is the point of time at which the bus level is read and interpreted as the
value of the respective bit. Its location is at the end of Phase Segment 1 (between the
two Phase Segments).
Phase Segment 2
This segment is also used to compensate for edge phase errors.
This segment may be shortened during resynchronization, but the length has to be at
least as long as the information processing time and may not be more than the length of
Phase Segment 1.
Information Processing Time
It is the time required for the logic to determine the bit level of a sampled bit.
The Information processing Time begins at the sample point, is measured in TQ and is
fixed at 2 TQ for the Atmel CAN. Since Phase Segment 2 also begins at the sample
point and is the last segment in the bit time, Phase Segment 2 minimum shall not be
less than the Information processing Time.
Bit Lengthening
As a result of resynchronization, Phase Segment 1 may be lengthened or Phase Seg-
ment 2 may be shortened to compensate for oscillator tolerances. If, for example, the
transmitter oscillator is slower than the receiver oscillator, the next falling edge used for
resynchronization may be delayed. So Phase Segment 1 is lengthened in order to
adjust the sample point and the end of the bit time.
Time Quantum
(producer)
Nominal CAN Bit Time
Segments
(producer)
SYNC_SEG
PROP_SEG
PHASE_SEG_1
PHASE_SEG_2
propagation
delay
Segments
(consumer)
SYNC_SEG
PROP_SEG
PHASE_SEG_1
PHASE_SEG_2
Sample Point
Transmission Point
(producer)
CAN Frame
(producer)
相關PDF資料
PDF描述
T89C51RD2-DDFI-M 0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDSC-L 0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDSC-M 0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDSI-L 0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDSI-M 0 to 40MHz Flash Programmable 8-bit Microcontroller
相關代理商/技術參數
參數描述
T89C51RD2-DDFI-M 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDRC-L 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDRC-M 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDRI-L 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:0 to 40MHz Flash Programmable 8-bit Microcontroller
T89C51RD2-DDRI-M 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:0 to 40MHz Flash Programmable 8-bit Microcontroller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*