- 您現在的位置：買賣IC網 > PDF目錄372371 > SUB60N04-15L Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode PDF資料下載
參數資料
| 型號： | SUB60N04-15L |
| 元件分類： | 參考電壓二極管 |
| 英文描述： | Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode |
| 中文描述： | 250 的低電流運算，低反向泄露，低噪聲穩壓二極管 |
| 文件頁數： | 8/8頁 |
| 文件大小： | 112K |
| 代理商： | SUB60N04-15L |
SUB60N04-15LT
Vishay Siliconix
New Product
www.vishay.com FaxBack 408-970-5600
2-8
Document Number: 70942
S-00718—Rev. C, 03-Apr-00
The bias current of 250- A nominal is derived from the input
signal. In this manner, a simple comparator can be used as a
driver for normal on/off operation and a fault detector circuit.
The circuit used to provide the input signal must therefore be
able to source 0.25 mA with no significant voltage drop.
The LMV321 can provide a output current of 60-mA typical,
which provides reasonable switching time for non-PWM
applications. A 560- resistor is added in series to protect the
op amp and to prevent instability, but will result in switching
times of several micro seconds. A lower value may be possible
depending
on
layout,
but
recommended by the op amp manufacturer.
may
violate
conditions
Hysteresis is added by means of a resistor network around the
comparator. Approximately 40 C hysteresis is added using
the components shown. This hysteresis could be reduced if
necessary by increasing the value of R4. Another means of
implementing hysteresis is to use the output of the comparator
to provide some of the bias current for the sensing diode. When
the comparator output is low (tripped/off), the bias current is
reduced by, say, 150 A, causing the forward voltage to drop
by around 50 mV. This concept would also allow a lower
sourcing capability in the logic circuit providing the on/off signal
and therefore should be used if input current requirements
become a problem.
With the input high, bias current flows and as long as the
forward voltage of the diode is higher than 0.465 V, the
comparator output is high and the MOSFET is on. If the forward
voltage of the diode drops below 0.465 V, the comparator
output goes low and the MOSFET is turned off. The gate drive
voltage can also be used as an output signal (if required) for
logic to interpret and to signify that there is a fault. Note the
cathode of the sensing diode should NOT be connected
directly to the source of the MOSFET as the noise introduced
by high currents in the source loop could affect operation of the
sensing circuit. A separate signal ground should be used and
connect to power ground at one point only.
A variation on this schematic is shown in Figure 2. Here a low
cost comparator (again in a SOT-23 or SC-70) is used to
provide a fault output signal only. The diode bias current is
taken from the 5 V. In this manner the diode bias is applied at all
times, so the noise filtering capacitor, C1 will not introduce a
turn-on delay. The fault output signal could be used to enable
the gate driver as shown, or fed to larger monitoring circuit to
shutdown the MOSFET.
FIGURE 2.
–
+
C1
560 pF
C3
0.1 F
R4, 560 k , 1%
IC1, LMV331
R2
22 k
1%
R1
180 k
1%
C2
0.1 F
+5 V
R3, 18 k
Power Ground
Signal Ground
S
IN
ENABLE
DRIVER
R5
10 k
R6
10 k
1%
相關PDF資料 |
PDF描述 |
|---|---|
| SUB60N04-15LT | Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode |
| SUB70N03-09BP | Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode |
| SUB70N04-10 | TRANSISTOR | MOSFET | N-CHANNEL | 40V V(BR)DSS | 70A I(D) | TO-263AB |
| SUP70N04-10 | TRANSISTOR | MOSFET | N-CHANNEL | 40V V(BR)DSS | 70A I(D) | TO-220AB |
| SUD40N06-24 | Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SUB60N04-15LT | 功能描述:MOSFET 40V 60A 110W RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
| SUB60N06-18 | 功能描述:MOSFET 60V 60A 120W RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
| SUB60N06-18-E3 | 功能描述:MOSFET 60V 60A 120W RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
| SUB61/6100A/100R/ | 制造商:Eurotherm Inc 功能描述:SHUNT RESISTOR, Sensing Element:-, Operating Temperature Min:0C, Operating Temp |
| SUB61/6100A/250R/ | 制造商:Eurotherm Inc 功能描述:SHUNT RESISTOR, Sensing Element:-, Operating Temperature Min:0C, Operating Temp |
發布緊急采購，3分鐘左右您將得到回復。