REV. 4.4.1 2.97V TO 5.5V DUART WITH 16-BYTE FIFO MSR[7]: CD Input Status Normally this bit is the compliment of the CD# input. In " />
參數資料
型號: ST16C2550CJ44TR-F
廠商: Exar Corporation
文件頁數: 18/37頁
文件大?。?/td> 0K
描述: IC UART FIFO 16B DUAL 44PLCC
標準包裝: 500
特點: *
通道數: 2,DUART
FIFO's: 16 字節
規程: RS232,RS485
電源電壓: 2.97 V ~ 5.5 V
帶故障啟動位檢測功能:
帶調制解調器控制功能:
帶CMOS:
安裝類型: 表面貼裝
封裝/外殼: 44-LCC(J 形引線)
供應商設備封裝: 44-PLCC(16.59x16.59)
包裝: 帶卷 (TR)
ST16C2550
25
REV. 4.4.1
2.97V TO 5.5V DUART WITH 16-BYTE FIFO
MSR[7]: CD Input Status
Normally this bit is the compliment of the CD# input. In the loopback mode this bit is equivalent to bit-3 in the
MCR register. The CD# input may be used as a general purpose input when the modem interface is not used.
4.10
Scratch Pad Register (SPR) - Read/Write
This is a 8-bit general purpose register for the user to store temporary data. The content of this register is
preserved during sleep mode but becomes 0xFF (default) after a reset or a power off-on cycle.
4.11
Baud Rate Generator Registers (DLL and DLM) - Read/Write
The Baud Rate Generator (BRG) is a 16-bit counter that generates the data rate for the transmitter. The rate is
programmed through registers DLL and DLM which are only accessible when LCR bit-7 is set to ‘1’. See
TABLE 11: UART RESET CONDITIONS FOR CHANNEL A AND B
DLM
Bits 7-0 = 0xXX
DLL
Bits 7-0 = 0xXX
RHR
Bits 7-0 = 0xXX
THR
Bits 7-0 = 0xXX
IER
Bits 7-0 = 0x00
FCR
Bits 7-0 = 0x00
ISR
Bits 7-0 = 0x01
LCR
Bits 7-0 = 0x00
MCR
Bits 7-0 = 0x00
LSR
Bits 7-0 = 0x60
MSR
Bits 3-0 = Logic 0
Bits 7-4 = Logic levels of the inputs inverted
SPR
Bits 7-0 = 0xFF
TX
Logic 1
OP2#
Logic 1
RTS#
Logic 1
DTR#
Logic 1
RXRDY#
Logic 1
TXRDY#
Logic 0
INT
Three-State Condition
REGISTERS
RESET STATE
I/O SIGNALS
RESET STATE
相關PDF資料
PDF描述
XR16V2750IMTR-F IC UART FIFO 64B DUAL 48TQFP
XR88C681CJTR-F IC UART CMOS DUAL 44PLCC
ST16C2550IQ48TR-F IC UART FIFO 16B DUAL 48TQFP
XR16C2550IMTR-F IC UART FIFO 16B DUAL 48TQFP
ST78C34CP40-F IC UART FIFO 83B 40PDIP
相關代理商/技術參數
參數描述
ST16C2550CP40 功能描述:UART 接口集成電路 DUAL UART W/16 BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
ST16C2550CP40-F 功能描述:UART 接口集成電路 DUAL UART W/16 BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
ST16C2550CQ-0A-EB 功能描述:界面開發工具 EVAL SYSTEM RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
ST16C2550CQ-0B-EB 功能描述:界面開發工具 Supports C2550 48 ld TQFP, PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
ST16C2550CQ48 制造商:Exar Corporation 功能描述: