- 您現在的位置：買賣IC網 > PDF目錄385855 > SP6121CN Low Voltage, Synchronous Step Down PWM Controller Ideal for 2A to 10A, Small Footprint, DC-DC Power Converters PDF資料下載
參數資料
| 型號： | SP6121CN |
| 英文描述： | Low Voltage, Synchronous Step Down PWM Controller Ideal for 2A to 10A, Small Footprint, DC-DC Power Converters |
| 中文描述： | 低電壓，為第2A同步降壓PWM控制器的理想下至10A，占地面積小，DC - DC電源轉換器 |
| 文件頁數： | 7/16頁 |
| 文件大?。?/td> | 358K |
| 代理商： | SP6121CN |
Date: 5/25/04
SP6121 Low Voltage, Synchronous Step Down PWM Controller Copyright 2004 Sipex Corporation
7
Over Current Protection
Over current protection on the SP6121 is imple-
mented through detection of an excess voltage
condition across the high side PMOS switch
during conduction. This is typically referred to
as high side R
DS(ON)
detection and eliminates the
need of an external sense resistor. The over
current comparator charges an internal sam-
pling capacitor each time V
(ISET)
- V
(ISENSE)
exceeds the 160mV (typ) internal threshold and
the PDRV voltage is low. The discharge/charge
current ratio on the sampling capacitor is about
2%. Therefore, provided that the over current
condition persists, the capacitor voltage will be
pumped up during each time PDRV switches
low. This voltage will trigger an over current
condition upon reaching a CMOS inverter thresh-
old. There are many advantages to this ap-
proach. First, the filtering action of the gated S/
H scheme protects against false and undesirable
triggering that could occur during a minor tran-
sient overload condition or supply line noise.
Furthermore, the total amount of time to trigger
the fault depends on the on-time of the PMOS
switch. Ten, 1
μ
s pulses are equivalent to twenty,
500ns pulses or one, 10
μ
s pulse, however, de-
pending on the period, each scenario takes a
different amount of total time to trigger a fault.
Therefore, the fault becomes an indicator of
average power in the PMOS switch.
Although the 160 mV internal threshold is fixed,
the overall R
DS(ON)
detection voltage can be
increased by placing a resistor from I
SET
to the
source of the PMOS. A 30
μ
A sink current pro-
grams the additional voltage.
In order for the current limit circuit to operate
properly and accurately, the I
SET
and I
SENSE
pins
must be Kelvin connected to the high side
PMOS’s source and drain pins.
The 160mV threshold and 30
μ
A I
SET
current
have 3300 ppm/
°
C temperature coefficients in
an effort to first order match the thermal charac-
teristics of the R
DS(ON)
of the PMOS switch. It
assumed that the SP6121 will be used in com-
pact designs where there is a high amount of
thermal coupling between the PMOS and the
controller.
Output Drivers
The SP6121, unlike some other bipolar control-
ler IC’s, incorporates gate drivers with rail-to-
rail swing that help prevent spurious turn on due
to capacitive coupling. The driver stage consists
of one high side PMOS, 4
driver, PDRV, and
one low side, 4
, NFET driver, NDRV, opti-
mized for driving external power MOSFET’s in
a synchronous buck topology. The output driv-
ers also provide gate drive non-overlap mecha-
nism that provides a dead time between PDRV
and NDRV transitions to avoid potential shoot-
through problems in the external MOSFET’s.
Figure 3 shows typical waveforms for the output
drivers. As with all synchronous designs, care
must be taken to ensure that the MOSFETs are
properly chosen for non-overlap time, enhance-
ment gate drive voltage, “on” resistance R
DS(ON)
,
reverse transfer capacitance Crss, input voltage
and maximum output current.
TIME
NDRV
Voltage
PDRV
Voltage
V(V
CC
)
- V(Diode) V
~ 0 V
Voltage
SWN
V(V
CC
)
0 V
0 V
V(V
CC
=V
IN
)
Vcc-2 V
NON-OVERLAP
2 V
10 %
RISE TIME
10 %
90 %
FALL TIME
NDRV(PDRV)
PDRV(NDRV)
5 V
90 %
5 V
GATE DRIVER TEST CONDITIONS
Figure 3. SP6121 Output Driver Waveforms.
THEORY OF OPERATION: continued
相關PDF資料 |
PDF描述 |
|---|---|
| SP6121EB | Demo Board Manual |
| SP6132H | High Voltage, 300KHz Synchronous PWM Controller |
| SP6132HEU | High Voltage, 300KHz Synchronous PWM Controller |
| SP6134 | Dual Supply Synchronous Buck Controller |
| SP6134CU | Dual Supply Synchronous Buck Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP6121CN/TR | 功能描述:開關變換器、穩壓器與控制器 Low Voltage, 8 Pin Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| SP6121CN-L | 功能描述:電壓模式 PWM 控制器 Low Voltage, 8 Pin Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| SP6121CN-L/TR | 功能描述:電壓模式 PWM 控制器 Low Voltage, 8 Pin Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| SP6121EB | 功能描述:電壓模式 PWM 控制器 Low Voltage, 8 Pin Sync Buck Controller RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓?fù)浣Y(jié)構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| SP6122 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Voltage, Micro 8, PFET, Buck Controller Ideal for 1A to 5A, Small Footprint, DC-DC Power Converters |
發布緊急采購，3分鐘左右您將得到回復。