- 您現在的位置：買賣IC網 > PDF目錄385838 > SE567 (NXP Semiconductors N.V.) Tone decoder/phase-locked loop PDF資料下載
參數資料
| 型號： | SE567 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Tone decoder/phase-locked loop |
| 中文描述： | 音解碼器/鎖相環 |
| 文件頁數： | 10/13頁 |
| 文件大?。?/td> | 165K |
| 代理商： | SE567 |
Philips Semiconductors Linear Products
Product specification
NE/SE567
Tone decoder/phase-locked loop
April 15, 1992
412
CHATTER PREVENTION
(Figure 4)
Chatter occurs in the output stage when C
3
is relatively small, so
that the lock transient and the AC components at the quadrature
phase detector (lock detector) output cause the output stage to
move through its threshold more than once. Many loads, for
example lamps and relays, will not respond to the chatter. However,
logic may recognize the chatter as a series of outputs. By feeding
the output stage output back to its input (Pin 1) the chatter can be
eliminated. Three schemes for doing this are given in Figure 4. All
operate by feeding the first output step (either on or off) back to the
input, pushing the input past the threshold until the transient
conditions are over. It is only necessary to assure that the feedback
time constant is not so large as to prevent operation at the highest
anticipated speed. Although chatter can always be eliminated by
making C
3
large, the feedback circuit will enable faster operation of
the 567 by allowing C
3
to be kept small. Note that if the feedback
time constant is made quite large, a short burst at the input
frequency can be stretched into a long output pulse. This may be
useful to drive, for example, stepping relays.
DETECTION BAND CENTERING (OR SKEW)
ADJUSTMENT
(Figure 5)
When it is desired to alter the location of the detection band
(corresponding to the loop capture range) within the lock range, the
circuits shown above can be used. By moving the detection band to
one edge of the range, for example, input signal variations will
expand the detection band in only one direction. This may prove
useful when a strong but undesirable signal is expected on one side
or the other of the center frequency. Since R
B
also alters the duty
cycle slightly, this method may be used to obtain a precise duty
cycle when the 567 is used as an oscillator.
ALTERNATE METHOD OF BANDWIDTH
REDUCTION
(Figure 6)
Although a large value of C
2
will reduce the bandwidth, it also
reduces the loop damping so as to slow the circuit response time.
This may be undesirable. Bandwidth can be reduced by reducing
the loop gain. This scheme will improve damping and permit faster
operation under narrow-band conditions. Note that the reduced
impedance level at terminal 2 will require that a larger value of C
2
be
used for a given filter cutoff
frequency. If more than three 567s are to be used, the network of R
B
and R
C
can be eliminated and the R
A
resistors connected together.
A capacitor between this junction and ground may be required to
shunt high frequency components.
OUTPUT LATCHING
(Figure 7)
To latch the output on after a signal is received, it is necessary to
provide a feedback resistor around the output stage (between Pins 8
and 1). Pin 1 is pulled up to unlatch the output stage.
REDUCTION OF C1 VALUE
For precision very low-frequency applications, where the value of C
1
becomes large, an overall cost savings may be achieved by
inserting a voltage-follower between the R
1
C
1
junction and Pin 6,
so as to allow a higher value of R
1
and a lower value of C
1
for a
given frequency.
PROGRAMMING
To change the center frequency, the value of R
1
can be changed
with a mechanical or solid state switch, or additional C
1
capacitors
may be added by grounding them through saturating NPN
transistors.
相關PDF資料 |
PDF描述 |
|---|---|
| SE567D | Tone decoder/phase-locked loop |
| SE567N | Tone decoder/phase-locked loop |
| SE701 | SILICON GATE ENHANCEMENT MODE RF POWER VDMOS TRANSISTOR |
| SEA Series | SRAM Memory Card 128 kB Through512 kB(128 kB - 512 kB靜態RAM存儲器卡) |
| SED10HB45 | 10 AMP 45 VOLTS SCHOTTKY RECTIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SE567D | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Tone decoder/phase-locked loop |
| SE567FE | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Tone decoder/phase-locked loop |
| SE567N | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Tone decoder/phase-locked loop |
| SE57 | 制造商:MISCELLANEOUS 功能描述: |
| SE-57 | 制造商:USM-EYELETS 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。