
TC1762
Electrical Parameters
Preliminary
Data Sheet
70
V1.0, 2008-04
Inactive device pin current
(V
DD =VDDP =0)
I
ID
SR
-1
1
mA
Voltage on all
power supply
pins V
DDx =0
External load capacitance
C
L
SR
–
See
DC
chara
cterist
ics
pF
Depending on
pin class
1) Digital supply voltages applied to the TC1762 must be static regulated voltages which allow a typical voltage
swing of
±5%.
2) Voltage overshoot up to 1.7 V is permissible at Power-Up and PORST low, provided the pulse duration is less
than 100
s and the cumulated summary of the pulses does not exceed 1 h.
3) Voltage overshoot to 4 V is permissible at Power-Up and PORST low, provided the pulse duration is less than
100
s and the cumulated summary of the pulses does not exceed 1 h.
4) The TC1762 uses a static design, so the minimum operation frequency is 0 MHz. Due to test time restriction
no lower frequency boundary is tested, however.
5) The PLL jitter characteristics add to this value according to the application settings. See the PLL jitter
parameters.
6) Applicable for digital outputs.
7) See additional document “TC1796 Pin Reliability in Overload“ for overload current definitions.
Table 4-3
Operating Condition Parameters
Parameter
Symbol
Limit
Values
Unit Notes
Conditions
Min.
Max.