- 您現在的位置：買賣IC網 > PDF目錄372108 > SAA2520 (NXP Semiconductors N.V.) Stereo filter and codec for MPEG layer 1 audio applications PDF資料下載
參數資料
| 型號： | SAA2520 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | Codec |
| 英文描述： | Stereo filter and codec for MPEG layer 1 audio applications |
| 中文描述： | 過濾器和立體聲的MPEG編解碼器1層音頻應用 |
| 文件頁數： | 25/36頁 |
| 文件大?。?/td> | 151K |
| 代理商： | SAA2520 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
August 1993
25
Philips Semiconductors
Preliminary specification
Stereo filter and codec for MPEG layer 1
audio applications
SAA2520
Table 13
MODE identification.
msb
lsb
mode
output
0
0
1
1
0
1
0
1
stereo
joint stereo
2 channel mono
1 channel mono
L and R
L and R
I or II as selected
mono; no selection
Ready-to-receive indicates whether the SAA2520 is ready
to receive allocation, scale factor or internal setting
transfers. This should be checked in order to synchronize
the transfer of such information.
In 2 channel mono decode mode the selected samples are
transferred to both output channels. The same occurs with
all samples in 1-channel mono decode mode. In both of
these instances the L and R filter output channels are
identical.
In decode mode the SYNC bit is logic 0 when the SAA2520
is unable to decode the sub-band frames. This will occur in
the following situations:
with the loss of synchronisation
when in correct allocation information is received for two
or more subsequent frames (SBEF was HIGH).
when the URDA input pin is HIGH
In these situations the SAA2520 data output will be muted.
The SYNC bit will return to logic 1 as soon as the decoder
is resynchronized to the incoming sub-band data.
CLKOK indicates whether the 256FS clock corresponds to
specified sample frequency. The CLKOK bit is set to logic
1 after a change in sample frequency, operation mode or
EXT256FS setting. It drops to logic 0 as soon as the
256FS clock deviates from the nominal frequency by more
than approximately 0.2%. Return to logic 1 will only occur
automatically when the extended setting
CLKOK-hold-mode is logic 0.
The transparent bits are copied from the MPEG coded
signal.
The EMPHASIS indication is as defined in the internal
settings. It can be used to apply the correct de-emphasis.
Note: the two bytes of the status are 'sampled' at different
moments so the information may not result from the same
sub-band frame.
相關PDF資料 |
PDF描述 |
|---|---|
| SAA3004 | Remote control transmitter |
| SAA3004P | Remote control transmitter |
| SAA3004T | Remote control transmitter |
| SAA3007 | INFRARED REMOTE CONTROL TRANSMITTER (LOW VOLTAGE) |
| SAA3007P | INFRARED REMOTE CONTROL TRANSMITTER (LOW VOLTAGE) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAA2520GP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Stereo filter and codec for MPEG layer 1 audio applications |
| SAA2521 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Masking threshold processor for MPEG layer 1 audio compression applications |
| SAA2521GP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Masking threshold processor for MPEG layer 1 audio compression applications |
| SAA2531DEB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| SA-A2870-FREQ | 制造商:NEL 制造商全稱:Nel Frequency Controls,inc 功能描述:Differential Positive ECL (DPECL) |
發布緊急采購，3分鐘左右您將得到回復。