
33
80960SB
5.0
REVISION HISTORY
This data sheet supersedes data sheet 272207-001. The sections significantly changed since the previous
revision are:
Data sheet 270917-004 applied to both the 80960SA and the 80960SB. The 80960SB was then documented
alone in data sheet 272207-001. The sections significantly changed between revisions -004 of the SA/SB data
sheet and 272207-001 of the SB data sheet were:
Section
Last
Rev.
Description
2.3 Connection Recommendations (pg. 11)
-001
Removed two LOCK pin Connection Recommendation
figures and added Figure 5 to reflect the new LOCK
pin connection recommendation of a single 910
pullup resistor.
2.5 Test Load Circuit (pg. 13)
-001
Obsolete figure (Test Load Circuit for Open-Drain
Output Pins) removed to reflect current test conditions.
2.7 DC Characteristics (pg. 14)
-001
IOL value improved.
WAS:
2.5 mA
IS:
4.0 mA
LOCK pin IOL value at 0.45V relaxed.
WAS:
12 mA
IS:
6 mA
LOCK pin IOL value at 0.60V deleted.
Section
Last
Rev.
Description
2.3 Connection Recommendations
(pg. 11)
-004
Deleted corresponding graph of open drain voltage vs. out-
put current.
Figure 7. Typical Supply Current vs.
Case Temperature (pg. 12)
Figure 8. Typical Current vs. Fre-
quency (Room Temp) (pg. 12)
Figure 9. Typical Current vs. Fre-
quency (Hot Temp) (pg. 13)
-004
Regraphed data in three graphs instead of two.
Table 6. DC Characteristics (pg. 15)
-004
Input Leakage Current (ILI2) Specification added to accu-
rately describe leakage of INT0 and LOCK as inputs.
Table 7. 80960SA AC Characteristics
(10 MHz) (pg. 17)
Table 8. 80960SA AC Characteristics
(16 MHz) (pg. 18)
-004
T7 minimum specification improved:
Power Supply Current:
Was:
Is:
10 MHz
24 ns
T1 - 11 ns
16 MHZ
15 ns
T1 - 11 ns
NOTES:
Page numbers refer to 80960SB data sheet number 272207-001.