參數資料
型號: S1M8836X01-G0T0
元件分類: PLL合成/DDS/VCOs
英文描述: PLL FREQUENCY SYNTHESIZER, 1000 MHz, CQCC24
封裝: 3.50 X 4.50 MM, QFN-24
文件頁數: 5/29頁
文件大小: 234K
代理商: S1M8836X01-G0T0
FRACTIONAL-N RF/INTEGER-N IF DUAL PLL
S1M8836/37
13
ΣΣ - modulator
The RF part of S1M8836/37 adopts the
Σ - modulator as a core of the fractional counter that makes it possible
to obtain divide ratio N to be a fractional number between two contiguous integers. The
Σ - modulator
effectively randomizes the quantization noise generated from digitizing process and results in extreme
suppression of in-band noise power by pushing it out to out-of-band as in conventional
Σ - data converter.
This technique eliminates the need for compensation current injection into the loop filter and improves fractional
spurious performance, suitable for high-tier applications.
The
Σ - modulator operates only for fractional-N mode, when the Frac-N_SEL is HIGH.
For proper use of the fractional mode, the user should be kept in mind that
1.
A fractional number should be set in the range from -0.5 to 0.5 in step of 1/62976.
2.
For S1M8836/7, R can be selected 1-3. The clock frequency fixed at 9.84MHz (=19.68MHz/2, R=2) is
recommended for the
Σ - modulator which is an optimum condition for achieving good electrical
performances related to the fractional noise and power consumption. Only when using this clock frequency,
the S1M8836/37 guarantees the exact frequency resolutions: 10kHz for CDMA PCS and 30kHz for CDMA
cellular.
Note that the clock frequency much lower than 9.84MHz can deteriorate the fractional noise performance.
Users can use R=1 or R=3, too. For the case of R=1 or R=3, users must ask SAMSUNG for details.
Fractional noise performance may become better for R=1 (clock frequency=19.68MHz/1=19.68MHz). But the
RF operating frequency range may be shrinked for that case of R=1.
Phase-Frequency Detector (PFD) and Charge Pump (CP)
The RF/IF phase detector composed of PFD and CP outputs pump current into an external loop filter in
proportional to the phase difference between outputs of N and R counter. The phase detector has a better linear
transfer characteristic due to a feedback loop to eliminate dead zone. The polarity of the PFD can be
programmed using RF_PFD_POL/IF_PFD_POL depending on whether RF/IF VCO characteristics are positive or
negative. (Programmable descriptions for phase detection polarity)
Power-Down(or Power-Save) Control
Each PLL is individually power controlled by the enable pins (RF_EN and IF_EN pins) or program control bits
(PWDN, PWDN_RF/IF). The enable pins override the program control bits. When both enable pins are HIGH, the
program control bits determine the state of power control. Power down forces all the internal blocks to be
deactivated and the charge pump output to be in the TRISTATE. The control register, however, remains active
for serial programming and is capable of loading and latching in data during the power down.
相關PDF資料
PDF描述
S1P-SLV 1 CONTACT(S), FEMALE, TWO PART BOARD CONNECTOR, CRIMP
S1T0567X01-D0B0 TELECOM, TONE DECODER CIRCUIT, PDIP8
S1U2-12-RC 500 MHz - 2000 MHz RF/MICROWAVE SGL POLE SGL THROW SWITCH, 1.5 dB INSERTION LOSS
S2004VS2 4 A, 200 V, SCR, TO-251
S2010F126 10 A, 200 V, SCR
相關代理商/技術參數
參數描述
S1M8837 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:FRACTIONAL-N RF/INTEGER-N IF DUAL PLL
S1M8837X01-G0T0 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:FRACTIONAL-N RF/INTEGER-N IF DUAL PLL
S1MA 制造商:VISHAY 制造商全稱:Vishay Siliconix 功能描述:Standard Surface Mount Glass Passivated Rectifier
S1MA-E3/5AT 功能描述:整流器 1.0 Amp 1000 Volt 30A IFSM @ 8.3ms RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel
S1MA-E3/61T 功能描述:整流器 1.0 Amp 1000 Volt RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel