參數資料
型號: R5F2L3AACDFA
元件分類: 微控制器/微處理器
英文描述: 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
封裝: 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100
文件頁數: 39/74頁
文件大?。?/td> 959K
代理商: R5F2L3AACDFA
45
2588F–AVR–06/2013
ATtiny261/461/861
The Wathdog Timer can also be configured to generate an interrupt instead of a reset. This can
be very helpful when using the Watchdog to wake-up from Power-down.
To prevent unintentional disabling of the Watchdog or unintentional change of time-out period,
two different safety levels are selected by the fuse WDTON as shown in Table 8-1 Refer to
details.
Figure 8-7.
Watchdog Timer
8.3.1
Timed Sequences for Changing the Configuration of the Watchdog Timer
The sequence for changing configuration differs slightly between the two safety levels. Separate
procedures are described for each level.
8.3.1.1
Safety Level 1
In this mode, the Watchdog Timer is initially disabled, but can be enabled by writing the WDE bit
to one without any restriction. A timed sequence is needed when disabling an enabled Watch-
dog Timer. To disable an enabled Watchdog Timer, the following procedure must be followed:
1.
In the same operation, write a logic one to WDCE and WDE. A logic one must be writ-
ten to WDE regardless of the previous value of the WDE bit.
2.
Within the next four clock cycles, in the same operation, write the WDE and WDP bits
as desired, but with the WDCE bit cleared.
8.3.1.2
Safety Level 2
In this mode, the Watchdog Timer is always enabled, and the WDE bit will always read as one. A
timed sequence is needed when changing the Watchdog Time-out period. To change the
Watchdog Time-out, the following procedure must be followed:
Table 8-1.
WDT Configuration as a Function of the Fuse Settings of WDTON
WDTON
Safety
Level
WDT Initial
State
How to Disable the
WDT
How to Change Time-
out
Unprogrammed
1
Disabled
Timed sequence
No limitations
Programmed
2
Enabled
Always enabled
Timed sequence
O
S
C/2K
O
S
C/4K
O
S
C/
8
K
O
S
C/16K
O
S
C/
3
2K
O
S
C/64K
O
S
C/12
8
K
O
S
C/256K
O
S
C/512K
O
S
C/1024K
MCU RESET
WATCHDOG
PRESCALER
128 kHz
OSCILLATOR
WATCHDOG
RESET
WDP0
WDP1
WDP2
WDP3
WDE
相關PDF資料
PDF描述
R5F2L3ACCDFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L38CCNFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L388CNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP80
R5F2L3A8CNFA 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100
R5F2L36CCNFP 8-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數
參數描述
R5F2L3AACDFA#U0 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH
R5F2L3AACDFP#U1 制造商:Renesas Electronics Corporation 功能描述:
R5F2L3AACDFP#V0 制造商:Renesas Electronics Corporation 功能描述:R8C/L3AC 96K+4K/10K 100LQFP14X14 -40-+85 - Trays
R5F2L3AACNFA#U0 制造商:Renesas Electronics Corporation 功能描述:R8CL3AC 96+4KB 1.8/5.5V -20 TO 85C 100QFP - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 100LQFP
R5F2L3AACNFP#30 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 96KB FLASH 100LQFP 制造商:Renesas Electronics Corporation 功能描述:R8C Series 16 bit 10 kB RAM 96 kB Flash Single Chip Microcontroller SMT-LQFP-100