參數資料
型號： R5F21264JFP
元件分類： 微控制器/微處理器
英文描述： 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
封裝： 7 X 7 MM, 0.80 MM PITCH, PLASTIC, LQFP-32
文件頁數： 19/52頁
文件大?。?/td> 620K
代理商： R5F21264JFP
43
ATmega165A/PA/325A/PA/3250A/PA/645A/P/6450A/P [DATASHEET]
8285E–AVR–02/2013
11. System control and reset
11.1
Resetting the AVR
During reset, all I/O Registers are set to their initial values, and the program starts execution from the Reset Vec-
tor. The instruction placed at the Reset Vector must be a JMP – Absolute Jump – instruction to the reset handling
routine. If the program never enables an interrupt source, the Interrupt Vectors are not used, and regular program
code can be placed at these locations. This is also the case if the Reset Vector is in the Application section while
the Interrupt Vectors are in the Boot section or vice versa. The circuit diagram in Figure 11-1 on page 44 shows the
reset logic. Table 28-13 on page 297 defines the electrical parameters of the reset circuitry.
The I/O ports of the AVR are immediately reset to their initial state when a reset source goes active. This does not
require any clock source to be running.
After all reset sources have gone inactive, a delay counter is invoked, stretching the internal reset. This allows the
power to reach a stable level before normal operation starts. The time-out period of the delay counter is defined by
the user through the SUT and CKSEL Fuses. The different selections for the delay period are presented in ”Clock
11.2
Reset Sources
The Atmel ATmega165A/165PA/325A/325PA/3250A/3250PA/645A/645P/6450A/6450P has five sources of reset:
Power-on Reset
The MCU is reset when the supply voltage is below the Power-on Reset threshold (V
POT)
External Reset
The MCU is reset when a low level is present on the RESET pin for longer than the minimum pulse length
Watchdog Reset
The MCU is reset when the Watchdog Timer period expires and the Watchdog is enabled
Brown-out Reset
The MCU is reset when the supply voltage V
CC is below the Brown-out Reset threshold (VBOT) and the Brown-out
Detector is enabled
JTAG AVR Reset
The MCU is reset as long as there is a logic one in the Reset Register, one of the scan chains of the JTAG
system. Refer to the section ”IEEE 1149.1 (JTAG) Boundary-scan” on page 215 for details
相關PDF資料
PDF描述
R5F21276SDXXXFP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
R5F21276KFP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
R5F21274SDFP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
R5F21274SNFP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
R5F21274KXXXFP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP32
相關代理商/技術參數
參數描述
R5F21264JFP#U0 制造商:Renesas Electronics Corporation 功能描述:MCU 16-bit R8C CISC 16KB Flash 3.3V/5V 32-Pin LQFP Tray 制造商:Renesas Electronics Corporation 功能描述:R8C26 3/5V 16KB -40 85C 32LQFP - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 16BIT 16KB FLASH 32LQFP 制造商:Renesas Electronics Corporation 功能描述:R8C Series 16 bit 1 kB RAM 16 KB Flash Microcontroller - LQFP-32
R5F21264JFP#V0 功能描述:MCU FLASH 16K ROM 1K RAM 32-LQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:R8C/2x/26 標準包裝:96 系列:PIC® 16F 核心處理器:PIC 芯體尺寸:8-位 速度:20MHz 連通性:I²C，SPI 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:11 程序存儲器容量:3.5KB（2K x 14） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:128 x 8 電壓 - 電源 (Vcc/Vdd):2.3 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 包裝:管件
R5F21264JFP#W4 功能描述:MCU 16KB ROM 1KB RAM 32-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:R8C/2x/26 標準包裝:300 系列:78K0R/Ix3 核心處理器:78K/0R 芯體尺寸:16-位 速度:40MHz 連通性:3 線 SIO，I²C，LIN，UART/USART 外圍設備:DMA，LVD，POR，PWM，WDT 輸入/輸出數:27 程序存儲器容量:16KB（16K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:38-SSOP 包裝:托盤
R5F21264JXXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MCU
R5F21264KFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MCU
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*