參數資料
型號: PM6685TR
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, QCC32
封裝: 5 X 5 MM, 1 MM HEIGHT, 0.50 MM PITCH, LEAD FREE, VFQFPN-32
文件頁數: 22/52頁
文件大?。?/td> 2536K
代理商: PM6685TR
PM6685
Device description
29/52
7.8
Gate drivers
The integrated high-current drivers allow to use different power MOSFETs. The high side
driver MOSFET uses a bootstrap circuit which is indirectly supplied by LDO5 output. The
BOOT and PHASE pins work respectively as supply and return rails for the HS driver.
The low side driver uses the internal LDO5 output for the supply rail and PGND pin as return
rail.
An important feature of the gate drivers is the adaptive anti-cross conduction protection,
which prevents high side and low side MOSFETs from being on at the same time. When the
high side MOSFET is turned off the voltage at the phase node begins to fall. The low side
MOSFET is turned on when the voltage at the phase node reaches an internal threshold.
When the low side MOSFET is turned off, the high side remains off until the LGATE pin
voltage goes approximately under 1V.
The power dissipation of the drivers is a function of the total gate charge Qg of the external
power MOSFETs and of the switching frequency, as shown in the following equation:
Where Vdriver is the 5V driver supply.
7.9
Reference voltage and bandgap
The 1.237V(typ.) internal bandgap voltage is accurate to ±1% over the temperature range. It
is externally available (VREF pin) and can supply up to ±100
A and can be used as a
voltage threshold for the multifunction pins FSEL, SKIP and LDO3_SEL to select the
appropriate working mode. Bypass VREF to ground with a 100nF minimum capacitor.
If VREF goes below 0.87V(typ.) , the system detects a fault condition and all the circuitry is
turned off. A toggle on the input voltage (power on reset) or a toggle on SHDN pin is
necessary to restart the device.
An internal divider of the bandgap provides a voltage reference Vr of 0.9V. This voltage is
used as reference for the linear and the switching regulators outputs. The overvoltage
protection, the undervoltage protection and the power good signals are referred to Vr.
7.10
Internal linear regulators
The PM6685 has two linear regulators providing respectively 5V(LDO5) and 3.3V(LDO3) at
±2% accuracy. High side drivers, low side drivers and most of internal circuitry are supplied
by LDO5 output through VCC pin (an external RC filter may be applied between LDO5 and
VCC). Both linear regulators can provide an average output current of 50mA and a peak
output current of 100mA. Bypass both LDO5 and LDO3 outputs with a minimum 1
F
ceramic capacitor and a 4,7
F tantalum capacitor (ESR < 2). If the 5V output goes below
4V, the system detects a fault condition and all the circuitry is turned off. A power on reset or
a toggle on SHDN pin is necessary to restart the device.
sw
g
driver
f
Q
V
P
×
=
相關PDF資料
PDF描述
PM6686 SWITCHING CONTROLLER, QCC32
PM75B6L1C060 AC MOTOR CONTROLLER, DMA19
PMB2304T PLL FREQUENCY SYNTHESIZER, 220 MHz, PDSO14
PMB2306R PLL FREQUENCY SYNTHESIZER, 120 MHz, PDSO16
PMB2306T PLL FREQUENCY SYNTHESIZER, 120 MHz, PDSO14
相關代理商/技術參數
參數描述
PM6686 制造商:STMicroelectronics 功能描述:
PM6686TR 功能描述:DC/DC 開關控制器 Step-down Controller w/adj. voltages-dual RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
PM6-6F-L 功能描述:端子 Metric Fork Terminal non-insulated, 4.0 RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp
PM6-6R-D 制造商:Panduit Corp 功能描述:
PM6-6R-L 功能描述:端子 Metric Ring Terminal non-insulated, 2.5 RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp